IEC 61019-2-2005 PDF

IEC 61019-2-2005 PDF

Surface Acoustic Wave (SAW) Resonators - Part 2: Guide to the Use

$132.41 $264.81 -50%
Product Code: IEC 61019-2
Stock In Stock
Edition: 2.0
Published: 05/2005
Number of Pages: 32
File Size: 1 file, 859 Bytes

Available Options

Product Description

Surface Acoustic Wave (SAW) Resonators - Part 2: Guide to the Use

Introduction: This part of IEC 61019 gives practical guidance to the use of SAW resonators which are used in telecommunications, radio equipments and consumer products. IEC 61019-1 can be referred to for general information, standard values and test conditions. The features of these SAW resonators are small size, light weight, adjustment-free and high stability. In addition, the operating frequency of SAW resonators extends to the VHF and UHF ranges. This part has been compiled in response to a generally expressed desire on the part of both users and manufacturers for a guide to the use of SAW resonators, so that the resonators may be used to their best advantage. To this end, general and fundamental characteristics have been explained in this guide.

Scope: SAW resonators are now widely used in a variety of applications: VCR RF-converters, CATV local oscillators, measuring equipment, remote control and so on. While SAW resonators are also applied to narrow bandwidth filters, the scope of this part of IEC 61019 is limited to SAW resonators for oscillator applications It is not the aim of this guide to explain theory, nor to attempt to cover all the eventualities which may arise in practical circumstances. This guide draws attention to some of the more fundamental questions, which should be considered by the user before he places an order for a SAW resonator for a new application. Such a procedure will be the user's insurance against unsatisfactory performance. Standard specifications, such as those of the IEC of which this guide forms a part, and national specifications or detail specifications issued by manufacturers, will define the available combinations of resonance frequency, quality factor, motional resistance, parallel capacitance, etc. These specifications are compiled to include a wide range of SAW resonators with standardized performances. It cannot be over-emphasized that the user should, wherever possible, select his SAW resonators from these specifications, when available, even if it may lead to making small modifications to his circuit to enable the use of standard resonators. This applies particularly to the selection of the nominal frequency.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 61019-2-2005 PDF

IEC 61019-2-2005 PDF

$132.41 $264.81