IEC 61025-2006 PDF

IEC 61025-2006 PDF

Fault Tree Analysis (FTA)

$211.22 $422.43 -50%
Product Code: IEC 61025
Stock In Stock
Edition: 2.0
Published: 12/2006
Number of Pages: 112
File Size: 1 file, 1 Byte

Available Options

Product Description

Fault Tree Analysis (FTA)

Introduction: Fault tree analysis (FTA) is concerned with the identification and analysis of conditions and factors that cause or may potentially cause or contribute to the occurrence of a defined top event. With FTA this event is usually seizure or degradation of system perfomance, safety or other important operational attributes, while with STA (success tree analysis) this event is the attribute describing the success. FTA is often applied to the safety analysis of systems (such as transportation systems, power plants, or any other systems that might require evaluation of safety of their operation). Fault tree analysis can be also used for availability and maintainability analysis. However, for simplicity, in the rest of this standard the term “reliability” will be used to represent these aspects of system performance. This standard addresses two approaches to FTA. One is a qualitative approach, where the probability of events and their contributing factors, – input events – or their frequency of occurrence is not addressed. This approach is a detailed analysis of events/faults and is known as a qualitative or traditional FTA. It is largely used in nuclear industry applications and many other instances where the potential causes or faults are sought out, without interest in their likelihood of occurrence. At times, some events in the traditional FTA are investigated quantitatively, but these calculations are disassociated with any overall reliability concepts, in which case, no attempt t

Scope: This International Standard describes fault tree analysis and provides guidance on its application as follows: definition of basic principles; describing and explaining the associated mathematical modelling; explaining the relationships of FTA to other reliability modelling techniques; description of the steps involved in performing the FTA; identification of appropriate assumptions, events and failure modes; identification and description of commonly used symbols.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope
  • 61025 © IEC:2006

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 61025-2006 PDF

IEC 61025-2006 PDF

$211.22 $422.43