IEC 61109 CMV-2025 PDF

IEC 61109 CMV-2025 PDF

Insulators for overhead lines-Composite suspension and tension insulators with AC voltage greater than 1 000 V and DC voltage greater than 1 500 V-Definitions, test methods and acceptance criteria (Commented Version)

$422.44 $844.87 -50%
Product Code: IEC 61109 CMV
Stock In Stock
Edition: 3.0
Published: 02/2025
Number of Pages: 170
File Size: 1 file, 7 MB

Available Options

Product Description

Insulators for overhead lines – Composite suspension and tension insulators with AC voltage greater than 1 000 V and DC voltage greater than 1 500 V – Definitions, test methods and acceptance criteria (Commented Version)

Introduction: Composite suspension and tension 2 insulators (in the following the term "composite insulator" is used) consist of fibreglass insulating core, bearing the mechanical load protected by a polymeric housing, the load being transmitted to the core by metallic end fittings. Despite these common features, the materials used and the construction design details and manufacturing process used by different manufacturers may differ. Some tests have been grouped together as "Design tests", to be performed only once on insulators which satisfy the same design conditions. For all design tests of these composite suspension and tension insulators, the appropriate common clauses defined in IEC 62217 are applied. As far as practical, the influence of time on the electrical and mechanical properties of its components (core material, housing, interfaces etc.) and of the complete composite insulators has been considered in specifying the design tests to ensure a satisfactory lifetime under normally known stress conditions of transmission lines. Explanation of the principles of the damage limit, load coordination and testing are presented in Annex A. It has not been considered useful to specify a power arc test as a mandatory test. The test parameters are manifold and can have very different values depending on the configurations of the network and the supports and on the design of arc-protection devices. The heating effect of power arcs should need to be considered in the design of metal fittings

Contents:

  • FOREWORD
  • INTRODUCTION
  • 10 Type tests

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 61109 CMV-2025 PDF

IEC 61109 CMV-2025 PDF

$422.44 $844.87