IEC 61163-2-2020 PDF

IEC 61163-2-2020 PDF

Reliability stress screening-Part 2: Components

$132.41 $264.81 -50%
Product Code: IEC 61163-2
Stock In Stock
Edition: 2.0
Published: 03/2020
Number of Pages: 64
File Size: 1 file, 2 Bytes

Available Options

Product Description

Reliability stress screening – Part 2: Components

Introduction: Although first developed to stabilize the parameters of manufactured components (burn-in), reliability stress screening (RSS) can be used to remove from a component population the weaker components. This can be done at times where the manufacturing processes for components are difficult to control or for other reasons such as where the components need to be selected (re-qualified) to operate in harsher than usual operating conditions. This is also done where more narrow specifications are required for the application and no alternative courses of action are available. The use of RSS is normally only a temporary measure when early failures need to be avoided under a specific set of conditions as outlined above. RSS is an effective tool in identifying and removing flaws due to poor component design and manufacturing deficiencies.

Scope: This part of IEC 61163 provides guidance on RSS techniques and procedures for electrical, electronic, and mechanical components. This document is procedural in nature and is not, and cannot be, exhaustive with respect to component technologies due to the rapid rate of developments in the component industry. This document is: a) intended for component manufacturers as a guideline; b) intended for component users as a guideline to negotiate with component manufacturers on RSS requirements; c) intended to allow the planning of an RSS process in house to meet reliability requirements or to allow the re-qualification of components for specific, upgraded, environments; d) intended as a guideline to sub-contractors who provide RSS as a service. This document is not intended to provide test plans for specific components or for delivery of certificates of conformance for batches of components. The use of bi-modal Weibull analysis to select and optimize an RSS process without having to estimate the reliability and life time of all items is described.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 61163-2-2020 PDF

IEC 61163-2-2020 PDF

$132.41 $264.81