Circuit boards and circuit board assemblies – Design and use – Part 6-1: Land pattern design – Generic requirements for land pattern on circuit boards
Introduction: Explanation why the following standards will be replaced by the new IEC 6188-6 series: IEC 61188-5-1:2002, Printed boards and printed board assemblies – Design and use – Part 5‑1: Attachment (land/joint) considerations – Generic requirements IEC 61188-5-2:2003, Printed boards and printed board assemblies – Design and use – Part 5‑2: Attachment (land/joint) considerations – Discrete components IEC 61188-5-3:2007, Printed boards and printed board assemblies – Design and use – Part 5‑3: Attachment (land/joint) considerations – Components with gull-wing leads on two sides IEC 61188-5-4:2007, Printed boards and printed board assemblies – Design and use – Part 5‑4: Attachment (land/joint) considerations – Components with J leads on two sides IEC 61188-5-5:2007, Printed boards and printed board assemblies – Design and use – Part 5‑5: Attachment (land/joint) considerations – Components with gull-wing leads on four sides IEC 61188-5-6:2003, Printed boards and printed board assemblies – Design and use – Part 5‑6: Attachment (land/joint) considerations – Chip carriers with J-leads on four sides IEC 61188-5-8:2007, Printed board and printed board assemblies – Design and use – Part 5‑8: Attachment (land/joint) considerations – Area array components (BGA, FBGA, CGA, LGA) Content is mostly equivalent to IPC-782A with Amendments 1 and 2, which was replaced in 2002 by IPC-7351. The component spectrum and pitch levels have dramatically increased since publication of the IEC 61188-5 (all parts)
Scope: This part of IEC 61188 specifies the requirements for soldering surfaces on circuit boards. This includes lands and land pattern for surface mounted components and also solderable hole configurations for through-hole mounted components. These requirements are based on the solder joint requirements of the IEC 61191-1, IEC 61191-2, IEC 61191-3 and IEC 61191-4.
Contents:
- FOREWORD
- INTRODUCTION
- Scope