IEC 61196-1-212-2021 PDF

IEC 61196-1-212-2021 PDF

Coaxial communication cables-Part 1-212: Environmental test methods-UV stability

$72.51 $145.02 -50%
Product Code: IEC 61196-1-212
Stock In Stock
Edition: 1.0
Published: 07/2021
Number of Pages: 24
File Size: 1 file, 1 Byte

Available Options

Product Description

Coaxial communication cables – Part 1-212: Environmental test methods – UV stability

Introduction: UV hazard assessment for synthetic compounds is possible using a number of UV sources. For the purposes of this document, three alternative methods are given. 1) Method A uses a xenon arc source to simulate the UV effect on cable sheath. The effect is measured by the variation of mechanical characteristics and/or change in colour after exposure. 2) Method B uses a fluorescent lamp to simulate the UV effect on cable sheath. Two different lamps may be used: type I (called UV-A lamps) and type II (called UV-B lamps). The effect is measured, as for method A, by the variation of mechanical characteristics and/or change in colour after exposure. 3) Method C uses a mercury vapour lamp to simulate the UV effect on cable sheath. As for methods A and B, the effect is determined by the variation of mechanical characteristics and/or change in colour after exposure. This test has been typically used for telecommunication cables. For outdoor cable application only, the test specimens are periodically subjected to water attack, for methods A and B. A recent modification of method C now allows for a water immersion cycle. For method C, the round robin tests made without water (see Annex B) indicate the method may be applicable to outdoor environments. Other sources and determination methods are capable of detecting and analysing the UV hazard for a cable sheath. Examples of such methods are metal halide lamps or sunshine carbon arc lamps, in combination with proper filters in order to cut of

Scope: This part of IEC 61196 describes three methods to determine the UV resistance of sheath materials for electric and optical fibre cables. These tests apply for outdoor and indoor cable applications according to the product standard. The samples of sheath are taken from the finished cables. Although this test method is written principally for communication cables, it can be used for energy cables if called up by the relevant product standard. Where a sheath is of cross-linked (thermosetting) material, it is recalled that the preparation of moulded plaques is made before crosslinking. Methods differ by the nature of the UV source. Due to the excessive time to failure, the methods described are inappropriate to products where UV resistance is conferred by ≥2,0 % carbon black content meeting the requirements defined in IEC 60708.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 61196-1-212-2021 PDF

IEC 61196-1-212-2021 PDF

$72.51 $145.02