IEC 61215-1-4 (REDLINE + STANDARD)-2021 PDF

IEC 61215-1-4 (REDLINE + STANDARD)-2021 PDF

Terrestrial photovoltaic (PV) modules-Design qualification and type approval-Part 1-4: Special requirements for testing of thin-film Cu(In,Ga)(S,Se)2 based photovoltaic (PV) modules

$85.75 $171.50 -50%
Product Code: IEC 61215-1-4 (REDLINE + STANDARD)
Stock In Stock
Edition: 2.0
Published: 02/2021
Number of Pages: 48
File Size: 1 file, 2 MB

Available Options

Product Description

Terrestrial photovoltaic (PV) modules – Design qualification and type approval – Part 1-4: Special requirements for testing of thin-film Cu(In,Ga)(S,Se)2 based photovoltaic (PV) modules

Scope: This document lays down requirements for the design qualification of terrestrial photovoltaic modules suitable for long-term operation in open-air climates. The useful service life of modules so qualified will depend on their design, their environment and the conditions under which they are operated. Test results are not construed as a quantitative prediction of module lifetime. In climates where 98th percentile operating temperatures exceed 70 °C, users are recommended to consider testing to higher temperature test conditions as described in IEC TS 63126. Users desiring qualification of PV products with lesser lifetime expectations are recommended to consider testing designed for PV in consumer electronics, as described in IEC 63163 (under development). Users wishing to gain confidence that the characteristics tested in IEC 61215 appear consistently in a manufactured product may wish to utilize IEC 62941 regarding quality systems in PV manufacturing. This document is intended to apply to all thin-film Cu(In,Ga)(S,Se)2 based terrestrial flat plate modules. As such it addresses special requirements for testing of this technology supplementing IEC 61215-1:2021 and IEC 61215-2:2021 requirements for testing. This document does not apply to modules used with concentrated sunlight although it may be utilized for low concentrator modules (1 to 3 suns). For low concentration modules, all tests are performed using the irradiance, current, voltage and power levels expected at the design concentration. The object of this test sequence is to determine the electrical characteristics of the module and to show, as far as possible within reasonable constraints of cost and time, that the module is capable of withstanding prolonged exposure outdoors. Accelerated test conditions are empirically based on those necessary to reproduce selected observed field failures and are applied equally across module types. Acceleration factors may vary with product design and thus not all degradation mechanisms may manifest. Further general information on accelerated test methods including definitions of terms may be found in IEC 62506. Some long-term degradation mechanisms can only reasonably b

Contents:

  • FOREWORD
  • 11.10 UV preconditioning test (MQT 10)
  • 11.11 Thermal cycling test (MQT 11)
  • 11.12 Humidity-freeze test (MQT 12)
  • 11.13 Damp heat test (MQT 13)
  • 11.14 Robustness of terminations test (MQT 14)
  • 11.15 Wet leakage current test (MQT 15)
  • 11.16 Static mechanical load test (MQT 16)
  • 11.17 Hail test (MQT 17)
  • 11.18 Bypass diode testing (MQT 18)
  • 11.19 Stabilization (MQT 19)

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 61215-1-4 (REDLINE + STANDARD)-2021 PDF

IEC 61215-1-4 (REDLINE + STANDARD)-2021 PDF

$85.75 $171.50