Radiotherapy equipment – Coordinates, movements and scales
Introduction: RADIOTHERAPY is performed in medical centres where a variety of ME EQUIPMENT from different MANUFACTURERS is usually concentrated in the RADIOTHERAPY department. In order to plan and simulate the TREATMENT, set up the PATIENT and direct the RADIATION BEAM, such ME EQUIPMENT can be put in different angular and linear positions and, in the case of MOVING BEAM RADIOTHERAPY, can be rotated and translated during the IRRADIATION of the PATIENT. It is essential that the position of the PATIENT, and the dimensions, directions, and qualities of the RADIATION BEAM prescribed in the treatment plan, be set up or varied by programmes on the radiotherapy EQUIPMENT with accuracy and without misunderstanding. Standard identification and scaling of coordinates is required for ME used in RADIOTHERAPY, including RADIOTHERAPY SIMULATORS and ME EQUIPMENT used to take images during or in connection with RADIOTHERAPY, because differences in the marking and scaling of similar movements on the various types of ME EQUIPMENT used in the same department may increase the probability of error. In addition, data from ME EQUIPMENT used to evaluate the tumour region, such as ultrasound, X-ray, CT and MRI should be presented to the treatment planning system in a form which is consistent with the RADIOTHERAPY coordinate system. Coordinate systems for individual geometrical parameters are required in order to facilitate the mathematical transformation of points and vectors from one coordinate system to another.
Contents:
- FOREWORD
- INTRODUCTION
- 3.10 Table top coordinate system ("t") (Figures 10, 11, 18 and 19)
- 3.11 PATIENT coordinate system ("p") (Figures 17a and 17b)
- 3.12 Imager coordinate system ("i") and focus coordinate system ("o")
- 3.12.1 General
- 3.12.2 The imager coordinate system ("i")
- 3.12.3 Focus coordinate system ("o")