IEC 61223-3-4-2000 PDF

IEC 61223-3-4-2000 PDF

Evaluation and Routine Testing in Medical Imaging Departments - Part 3-4: Acceptance Tests - Imaging Performance of Dental X-Ray Equipment

$163.93 $327.86 -50%
Product Code: IEC 61223-3-4
Stock In Stock
Edition: 1.0
Published: 03/2000
Number of Pages: 42
File Size: 1 file, 127 Bytes

Available Options

Product Description

Evaluation and Routine Testing in Medical Imaging Departments - Part 3-4: Acceptance Tests - Imaging Performance of Dental X-Ray Equipment

Introduction: This part of IEC 61223 is part of a series of International Standards which gives methods of acceptance testing and constancy testing for subsystems and systems (for example, diagnostic X-RAY EQUIPMENT) including film processing. Some provisions or statements in this standard require additional information. Such information is presented in annex B. An asterisk in the left margin of a clause or subclause indicates the presence of such additional information.

Scope: This part of IEC 61223 applies to those components of dental X-RAY EQUIPMENT using radiographic imaging systems which influence the image quality and PATIENT dose. This standard applies to the performance of the ACCEPTANCE TEST on dental X-RAY EQUIPMENT with intra-oral X-RAY IMAGE RECEPTOR and dental X-RAY EQUIPMENT with extra-oral X-RAY IMAGE RECEPTOR (for example, dental panoramic X-RAY EQUIPMENT or cephalometric X-RAY). This standard applies to dental film and digital image acquisition and processing. 1.2 Object This standard defines a) the essential parameters which describe the performance of the above-mentioned dental X-RAY EQUIPMENT with regard to imaging properties and PATIENT dose; b) methods of testing and whether measured quantities related to those parameters comply with the specified tolerances. These methods rely mainly on non-invasive measurements, using appropriate test equipment, performed during or after the installation is completed. Signed statements covering steps in the installation procedure may be used as part of the acceptance testing. The aim is to verify compliance of the installation with specifications affecting the image quality and PATIENT dose, and to detect malfunctions that are not in agreement with those specifications. This standard does not in itself specify tolerances for the parameters under investigation. Neither is it intended to consider c) aspects of mechanical and electrical safety; d) aspects of mechanical, electrical and software performance, unless they are essential to the performance of the tests directly affecting image quality and PATIENT dose. – 8 – 61223-3-4 © IEC:2000(E)

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 61223-3-4-2000 PDF

IEC 61223-3-4-2000 PDF

$163.93 $327.86