Fibre- optic communication subsystem test procedures – Part 4-2: Installed cabling plant – Single-mode attenuation and optical return loss measurements
Introduction: This document is part of a series of IEC standards for measurements of installed fibre optic cabling plants. This document is applicable for the measurement of installed single-mode fibres. Cabling design standards such as ISO/IEC 11801-1 provide general requirements for this type of cabling. These standards support cabling lengths of up to 2 km for commercial premises and data centres and up to 10 km for industrial premises. ISO/IEC 14763-3, which supports ISO/IEC 11801-1, normatively references IEC 61280-4-2. Various recommendations from ITU-T have requirements for longer distance applications, including short haul (40 km), long haul (80 km), and ultra-long haul (160 km). The testing of cabling plant for these applications is covered in ITU-T Recommendation G.650.3, which refers to the test methods of this document.
Scope: This part of IEC 61280 is applicable to the measurements of attenuation and optical return loss of an installed optical fibre cabling plant using single-mode fibre. This cabling plant can include single-mode optical fibres, connectors, adapters, splices, and other passive devices. The cabling can be installed in a variety of environments including residential, commercial, industrial and data centre premises, as well as outside plant environments. This document is applicable to all single-mode fibre types including those designated by IEC 60793-2-50 as Class B fibres. The principles of this document can be applied to cabling plants containing branching devices (splitters) and at specific wavelength ranges in situations where passive wavelength selective components are deployed, such as WDM, CWDM and DWDM devices. This document is not intended to apply to cabling plants that include active devices such as fibre amplifiers or dynamic channel equalizers.
Contents:
- FOREWORD
- INTRODUCTION
- Scope