IEC 61290-1-2 (REDLINE + STANDARD)-2026 PDF

IEC 61290-1-2 (REDLINE + STANDARD)-2026 PDF

Optical amplifiers - Test methods - Part 1-2: Power and gain parameters - Electrical spectrum analyzer method

$85.75 $171.50 -50%
Product Code: IEC 61290-1-2 (REDLINE + STANDARD)
Stock In Stock
Edition: 3.0
Published: 02/2026
Number of Pages: 52
File Size: 1 file, 850 KB

Available Options

Product Description

Optical amplifiers - Test methods - Part 1-2: Power and gain parameters - Electrical spectrum analyzer method

Introduction: This International Standard is devoted to the subject of optical amplifiers. The technology of optical amplifiers is still rapidly evolving, hence amendments and new editions to this standard can be expected. Each abbreviation introduced in this International Standard is explained in the text at least the first time it appears. However, for an easier understanding of the whole text, a list of all abbreviations used in this International Standard is given in Clause 3.

Scope: This part of IEC 61290 applies to all commercially available optical amplifiers (OAs) and optically amplified sub-systems. It applies to OAs using optically pumped fibres (OFAs based on either rare-earth doped fibres or on the Raman effect), semiconductors (SOAs), and planar optical waveguides (POWAs). This document does not apply to polarization-maintaining optical amplifiers. NOTE The applicability of the test methods described in the present standard to distributed Raman amplifiers is for further study. This document defines uniform requirements for accurate and reliable measurements, by means of the electrical spectrum analyzer test method, of the following OA parameters, as defined in IEC 61291-1, Clause 3: a) nominal output signal power; b) gain; c) reverse gain; d) maximum gain; e) polarization-dependent gain. f) large-signal output stability; g) saturation output power; h) maximum input signal power; i) maximum output signal power; j) input power range; k) output power range; l) maximum total output power. In addition, this test method provides a means for measuring the following parameters: maximum gain wavelength; gain wavelength band. NOTE All numerical values followed by (‡) are suggested values for which the measurement is assured. Other values may be acceptable, but should be verified. This document specifically covers single-channel amplifiers. For multichannel amplifiers, the IEC 61290-10 series1 applies. NOTE 1 The applicability of the test methods described in this document to distributed Raman amplifiers is for further study. NOTE 2 A test method for polarization-maintaining optical amplifiers is for further study. 1 See Bibliography. IEC 61290-1-2:2026 RLV © IEC 2026

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 61290-1-2 (REDLINE + STANDARD)-2026 PDF

IEC 61290-1-2 (REDLINE + STANDARD)-2026 PDF

$85.75 $171.50