IEC 61300-3-20-2001 PDF

IEC 61300-3-20-2001 PDF

Fibre Optic Interconnecting Devices and Passive Components - Basic Test and Measurement Procedures - Part 3-20: Examinations and Measurements - Directivity of Fibre Optic Branching Devices

$15.77 $31.53 -50%
Product Code: IEC 61300-3-20
Stock In Stock
Edition: 1.0
Published: 04/2001
Number of Pages: 18
File Size: 1 file, 477 Bytes

Available Options

Product Description

Fibre Optic Interconnecting Devices and Passive Components - Basic Test and Measurement Procedures - Part 3-20: Examinations and Measurements - Directivity of Fibre Optic Branching Devices

Scope: The purpose of this part of IEC 61300 is to measure the directivity of light between channels of a multiport non-wavelength-selective MxN fibre optic branching device. The directivity is defined as the fraction of the light that goes from an input path to another input optical path, normally isolated from the previous one. General description The measurement procedure of the directivity entails a comparison between two optical power level measurements. The reference power level is the optical power measured from a fibre which is connected to an optical source. The directivity is the measured optical power at an input port that is normally optically isolated from the reference input when it is connected to the optical source. The directivity is then given by the ratio of these two power level measurements, expressed in decibels (dB). Since directivity levels of concern for practical use of fibre optic branching devices can be very small, even of the order of 70 dB, the relevant measurement can be degraded by several factors. Therefore this procedure is designed to either circumvent these factors, or to point them out so that adequate care and choice of test apparatus can be taken. Factors which can degrade a measurement of directivity include: coupling of ambient light into measurement channels; reflection of light from the ends of fibre pigtails; light carried in cladding modes; accuracy of the power meter at low light levels; fibre pigtail lengths since light can scatter (Rayleigh scattering) along the pigtails. Apparatus The apparatus consists of: 3.1 Optical source (S) The source is pigtailed or connected to a launch optical fibre compatible with the input port of the branching device under test (BD). It is also designed/conditioned so that cladding modes are suppressed at the output. For measurements of BDs which are not inherently broad band in optical performance, the bandwidth of the light source shall fall within the BD operative wavelength range; in particular the emitted power of the source in the BD band shall be greater than the power source level outside the same band by at least 10 dB. Moreover the output power of the light source shall also be hig

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 61300-3-20-2001 PDF

IEC 61300-3-20-2001 PDF

$15.77 $31.53