IEC 61300-3-35 (REDLINE + STANDARD)-2015 PDF

IEC 61300-3-35 (REDLINE + STANDARD)-2015 PDF

Fibre optic interconnecting devices and passive components - Basic test and measurement procedures - Part 3-35: Examinations and measurements - Visual inspection of fibre optic connectors and fibre-stub transceivers

$171.50 $342.99 -50%
Product Code: IEC 61300-3-35 (REDLINE + STANDARD)
Stock In Stock
Edition: 2.0
Published: 06/2015
Number of Pages: 76
File Size: 1 file, 4 MB

Available Options

Product Description

Fibre optic interconnecting devices and passive components - Basic test and measurement procedures - Part 3-35: Examinations and measurements - Visual inspection of fibre optic connectors and fibre-stub transceivers

Scope: This part of IEC 61300 describes methods for quantitatively assessing the end face quality of a polished fibre optic connector or of a fibre optic transceiver using a fibre-stub type interface. The information is intended for use with other standards which set requirements for allowable surface defects such as scratches, pits and debris which may affect optical performance. Sub- surface cracks and fractures are not considered in this standard. In general, the methods described in this standard apply to 125 m cladding fibres contained within a ferrule and intended for use with sources of  2 W of input power. However, portions are applicable to non- ferruled connectors and other fibre types. Those portions are identified where appropriate. It is not the intention of this standard that the size of scratches should be measured, the dimensions and requirements are selected such that they can be estimated. There is no need to measure for example if a scratch is 2,3 µm wide.

Contents:

  • FOREWORD
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 61300-3-35 (REDLINE + STANDARD)-2015 PDF

IEC 61300-3-35 (REDLINE + STANDARD)-2015 PDF

$171.50 $342.99