IEC 61300-3-44-2012 PDF

IEC 61300-3-44-2012 PDF

Fibre optic interconnecting devices and passive components-Basic test and measurement procedures-Part 3-44: Examinations and measurements-Fibre optic transceiver receptacle endface visual and automated inspection

$50.44 $100.88 -50%
Product Code: IEC 61300-3-44
Stock In Stock
Edition: 1.0
Published: 08/2012
Number of Pages: 34
File Size: 1 file, 685 Bytes

Available Options

Product Description

Fibre optic interconnecting devices and passive components – Basic test and measurement procedures – Part 3-44: Examinations and measurements – Fibre optic transceiver receptacle endface visual and automated inspection

Scope: This part of IEC 61300 describes methods for quantitatively assessing the endface quality of an optic receptacle interface for single mode applications, equipped with transceivers such as SFP/XFP. Lens type and stub ferrule type interface configurations are designed for this interface, but this standard defines the end face quality of the stub ferrule type in this edition. The information is intended for use with other standards which set requirements for allowable surface defects such as scratches, pits and debris which may affect optical performance. In general, the methods described in this standard apply to 125 µm cladding fibres contained within a ferrule and intended for use with sources of ≤ 2 W of input power. Measurement 2.1 General The objective of this document is to prescribe methods for quantitatively inspecting fibre optic endfaces to determine if they are suitable for use. Two methods are described: A: video microscopy and B: automated analysis microscopy. Within each method, there are hardware requirements and procedures for both low resolution and high resolution systems. High resolution systems are to be utilized for critical examination of the glass fibre after polishing and upon incoming quality assurance. High resolution systems are typically not used during field polishing or in conjunction with multimode connectors. Low resolution systems are to be utilized prior to mating connectors for any purpose. All methods require a means for measuring and quantifying defects. There are many types of defects. Commonly used terminology would include: particles, pits, chips, scratches, embedded debris, loose debris, cracks, etc. For practical purposes, all defects will be categorized in one of two groups. They are defined as follows: scratches: permanent linear surface features; defects: all non-linear features detectable on the fibre. This includes particulates, other debris, pits, chips, edge chipping, etc. All defects and scratches are surface anomalies. Sub-surface cracks and fractures are not reliably detectable with a light microscope in all situations and are therefore not covered within this standard. Cracks and fractures to the fibre may be de

Contents:

  • FOREWORD
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 61300-3-44-2012 PDF

IEC 61300-3-44-2012 PDF

$50.44 $100.88