IEC 61300-3-52-2014 PDF

IEC 61300-3-52-2014 PDF

Fibre optic interconnecting devices and passive components-Basic test and measurement procedures-Part 3-52: Examinations and measurements-Guide hole and alignment pin deformation constant, CD for 8 degree angled PC rectangular ferrule, single mode fibres

$25.22 $50.44 -50%
Product Code: IEC 61300-3-52
Stock In Stock
Edition: 1.0
Published: 02/2014
Number of Pages: 22
File Size: 1 file, 283 Bytes

Available Options

Product Description

Fibre optic interconnecting devices and passive components – Basic test and measurement procedures – Part 3-52: Examinations and measurements – Guide hole and alignment pin deformation constant, CD for 8 degree angled PC rectangular ferrule, single mode fibres

Scope: This part of IEC 61300 describes a procedure to measure guide hole and alignment pin deformation constant, CD for 8 degree angled PC rectangular ferrule multi-fibre connectors. General description 2.1 General Alignment pin and ferrule deformation dependence on applied force at the pin edge can vary for different ferrule design attributes including material properties, internal geometry and surface roughness. The amount of deformation influences the amount of y-direction translation and therefore the nominal y-offset location of the fibre cores, Yi. Yi is described by the next expression and shown in Figure 1: Yi = α (ID-OD)/2 + CD where is the coefficient that depends on the difference between guide hole pitches for mated plugs; is the inside diameter of the guide hole; OD is the outside diameter of the alignment pin; is the alignment pin and guide hole deformation constant for an applied force of 0,7 N to each hole corresponding to the nominal mating force value of 9,8 N. ∅E U 2× ∅D Yi ∅A U IEC 0284/14 Figure 1 – Yi and CD definitions – 10 – 61300-3-52 © CEI:2014 AVANT-PROPOS .................................................................................................................. 11 Domaine d'application ................................................................................................... 13 Description générale ...................................................................................................... 13 2.1 Généralités ...................................................................................................... 13 2.2 Conditions d’essai ............................................................................................ 14 Appareillage .................................................................................................................. 14 3.1 Codeur linéaire de précision ............................................................................ 14 3.2 Préparation des échantillons ............................................................................ 15 Procédure ...................................................................................................................... 16 Détail

Contents:

  • FOREWORD
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 61300-3-52-2014 PDF

IEC 61300-3-52-2014 PDF

$25.22 $50.44