Waveguide type dielectric resonators Part 2: Guidelines for oscillator and filter applications
Introduction: This part of IEC 61338 gives practical guidance on the use of waveguide type dielectric resonators that are used in telecommunications and radar systems (for general information, standard values, and test conditions, see the other parts of this series). The features of these dielectric resonators are small size without degradation of quality factor, low mass, high reliability and high stability against temperature and ageing. The dielectric resonators are suitable for applications to miniaturized oscillators and filters with high performance. This standard has been compiled in response to a generally expressed desire on the part of both users and manufacturers for guidelines for the use of dielectric resonators, so that the resonators may be used to their best advantage. For this purpose, general and fundamental characteristics have been explained in this standard.
Scope: This part of IEC 61338, which contains guidelines for use, is limited to the waveguide type dielectric resonators that are used for oscillator and filter applications. These types of resonators are now widely used in oscillators for direct broadcasting or communication satellite systems, oscillators for radio links, voltage-controlled oscillators for mobile communication systems and so on. In addition, these dielectric resonators are also used as an essential component of miniaturized filters for the same kind of applications. It is not the aim of this standard either to explain theory or to attempt to cover all the eventualities that may arise in practical circumstances. This standard draws attention to some of the more fundamental questions, which should be considered by the user before he places an order for dielectric resonators for a new application. Such a procedure will be the user's insurance against unsatisfactory performance. Standard specifications, such as those in the IEC 61338 series and national specifications or detail specifications issued by manufacturers, will define the available combinations of resonance frequency, the quality factor, the temperature coefficient of resonance frequency, etc. These specifications are compiled to include a wide range of dielectric resonators with standardized performances. It cannot be over-emphasized that the user should, wherever possible, select his dielectric resonators from these specifications, when available, even if it may lead to making small modifications to his circuit to enable standard resonators to be used. This applies particularly to the selection of the nominal frequency.
Contents:
- FOREWORD
- INTRODUCTION
- Scope