IEC 61340-2-3 (REDLINE + STANDARD)-2016 PDF

IEC 61340-2-3 (REDLINE + STANDARD)-2016 PDF

Electrostatics - Part 2-3: Methods of test for determining the resistance and resistivity of solid materials used to avoid electrostatic charge accumulation

$225.09 $450.18 -50%
Product Code: IEC 61340-2-3 (REDLINE + STANDARD)
Stock In Stock
Edition: 2.0
Published: 06/2016
Number of Pages: 93
File Size: 1 file, 2.1 MB

Available Options

Product Description

Electrostatics - Part 2-3: Methods of test for determining the resistance and resistivity of solid materials used to avoid electrostatic charge accumulation

Introduction: Measurements of resistances and related calculations of resistivities belong to the fundamental objectives of electrical measuring techniques along with measurements of voltage and current. Resistivity is the electrical characteristic having the widest range, extending over some thirty orders of magnitude from the most conductive metal to almost perfect insulators. The basis is Ohm's law and is valid for DC current and instantaneous values of AC current in electron conductors (metals, carbon, etc.). Values of resistance measurements using AC current can be influenced by capacitive/inductive reactance, depending on the frequency. Thus, existing national and international standards dealing with resistance measurements of solid materials normally require the application of DC current. Most non-metal materials such as plastics are classified as polymers and ion conductors. The transport of charges can be dependent upon the applied electrical field strength during the measurement. Beside the measuring current, there exists a charging current that polarizes and/or electrostatically charges the material, indicated by an asymptotic decay of the measuring current with time and causing an apparent change in resistance. If this effect is observed, it will be advisable to repeat the measurement immediately after a definite electrification time has elapsed using the reverse polarity for the measuring current and averaging both obtained values.

Scope: This part of IEC 61340 describes test methods for the determination of the electrical resistance and resistivity of solid materials used to avoid electrostatic charge accumulation, in which the measured resistance is in the range 104 Ω to 1012 Ω. It takes account of existing IEC/ISO standards and other published information, and gives recommendations and guidelines on the appropriate method.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 61340-2-3 (REDLINE + STANDARD)-2016 PDF

IEC 61340-2-3 (REDLINE + STANDARD)-2016 PDF

$225.09 $450.18