IEC 61347-1 (REDLINE + STANDARD)-2015 PDF

IEC 61347-1 (REDLINE + STANDARD)-2015 PDF

Lamp controlgear - Part 1: General and safety requirements

$249.68 $499.36 -50%
Product Code: IEC 61347-1 (REDLINE + STANDARD)
Stock In Stock
Edition: 3.0
Published: 02/2015
Number of Pages: 380
File Size: 1 file

Available Options

Product Description

Lamp controlgear - Part 1: General and safety requirements

Introduction: This part of IEC 61347 provides a set of general and safety requirements and tests which are considered to be generally applicable to most types of lamp controlgear and which can be called up as required by the different parts that make up IEC 61347-2. This Part 1 is thus not to be regarded as a specification in itself for any type of lamp controlgear, and its provisions apply only to particular types of lamp controlgear, to the extent determined by the appropriate Part 2 of IEC 61347. The parts which make up IEC 61347-2, in referring to any of the clauses of this part, specify the extent to which such a clause is applicable and the order in which the tests are to be performed; they also include additional requirements as necessary. The order in which the clauses of this part are numbered has no particular significance, as the order in which their provisions apply is determined for each type of lamp controlgear by the appropriate Part 2 of the IEC 61347-2 series. All such parts are self-contained and therefore do not contain references to each other. Where the requirements of any of the clauses of this part of IEC 61347 are referred to in the various parts that make up IEC 61347-2 by the phrase "The requirements of clause n of IEC 61347-1 apply", this phrase will be interpreted as meaning that all requirements of the clause in question of Part 1 apply, except any which are clearly inapplicable to the particular type of lamp controlgear covered by the Part 2 concerned. Lamp co

Scope: This part of IEC 61347 specifies general and safety requirements for lamp controlgear for use on d.c. supplies up to 250 V and/or a.c. supplies up to 1 000 V at 50 Hz or 60 Hz. This standard also covers lamp controlgear for lamps which are not yet standardized. Tests dealt with in this standard are type tests. Requirements for testing individual lamp controlgear during production are not included. Requirements for semi-luminaires are given in IEC 60598-1:2014 (see definition 1.2.60). In addition to the requirements given in this Part 1 of IEC 61347, Annex B sets out general and safety requirements applicable to thermally protected lamp controlgear. Annex C sets out additional general and safety requirements as they apply to electronic lamp controlgear with means of protection against overheating. Additional requirements for built-in ballasts with double or reinforced insulation are given in Annex I. Particular requirements for controlgears providing safety extra low voltage (from now on SELV) are given in Annex L. It can be expected that lamp control gear which comply with this standard will not compromise safety between 90 % and 110 % of their rated supply voltage in independent use and when operated in luminaires complying with the safety standard IEC 60598-1 and the relevant part IEC 60598-2-xx and with lamps complying with the relevant lamp standards. Performance requirements may require tighter limits.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope
  • 30 kHz

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 61347-1 (REDLINE + STANDARD)-2015 PDF

IEC 61347-1 (REDLINE + STANDARD)-2015 PDF

$249.68 $499.36