Controlgear for electric light sources – Safety – Part 2-1: Particular requirements – Starting devices (other than glow starters)
Introduction: The technical requirements in this document compared to IEC 61347-2-1:2000, IEC 61347-2-1:2000/AMD1:2005 and IEC 61347-2-1:2000/AMD2:2013 are essentially unchanged. Nevertheless, a new edition of this document could not be avoided, as without the introduction of dated references to IEC 61347-1:2015 and IEC 61347-1:2015/AMD1:2017, the fourth edition of IEC 61347-1:—1 would have been implicitly applicable due to the undated nature of the references to IEC 61347-1 in IEC 61347-2-1:2000, IEC 61347-2-1:2000/AMD1:2005 and IEC 61347-2-1:2000/AMD2:2013. This document, in referring to any of the clauses of IEC 61347-1:2015 and IEC 61347-1:2015/AMD1:2017, specifies the extent to which such a clause is applicable. Additional requirements are also included, as necessary. ___________ Fourth edition under preparation. Stage at the time of publication IEC FDIS 61347-1:2024.
Scope: This part of IEC 61347 specifies safety requirements for starting devices (starters other than glow starters and ignitors) for fluorescent and other discharge lamps for use on AC supplies up to 1 000 V at 50 Hz or 60 Hz which produce starting pulses not greater than 100 kV and which are used in combination with lamps and controlgear covered in IEC 60081, IEC 60188, IEC 60192, IEC 60662, IEC 60901, IEC 61167, IEC 61195, IEC 61199, IEC 61347-2-8 and IEC 61347-2-9. This document does not apply to glow starters or starting devices which are incorporated in discharge lamps or which are manually operated. NOTE 1 Glow starters are dealt with in IEC 60155. NOTE 2 Performance requirements are given in IEC 60927.
Contents:
- FOREWORD
- INTRODUCTION
- Scope