Controlgear for electric light sources – Safety – Part 2-12: Particular requirements – DC or AC supplied electronic controlgear for discharge lamps (excluding fluorescent lamps)
Introduction: This standard, and the parts which make up IEC 61347-1, in referring to any of the clauses of IEC 61347-1 specify the extent to which such a clause is applicable and the order in which the tests are to be performed; they also include additional requirements as necessary. All parts which make up IEC 61347-2 are self-contained and therefore do not include references to each other. Where the requirements of any of the clauses of IEC 61347-1 are referred to in this standard by the phrase “The requirements of Clause n of IEC 61347-1 apply, this phrase is interpreted as meaning that all requirements of the clause in question of Part 1 apply, except any which are clearly inapplicable to the specific type of lamp controlgear covered by this particular part of IEC 61347-2. The technical requirements in this document compared to IEC 61347-2-12:2005 and IEC 61347-2-12:2005/AMD1:2010 are essentially unchanged. Nevertheless, a new edition of this document could not be avoided, as without the introduction of dated references to IEC 61347-1:2015 and IEC 61347-1:2015/AMD1:2017, the fourth edition of IEC 61347-1:—1 would have been implicitly applicable due to the undated nature of the references to IEC 613471 in IEC 61347-2-12:2005 and IEC 61347-2-12:2005/AMD1:2010. This document, in referring to any of the clauses of IEC 61347-1:2015 and IEC 61347-1:2015/AMD1:2017, specifies the extent to which such a clause is applicable. Additional requirements are also included, as necessary. ___________
Scope: This part of IEC 61347 specifies particular general and safety requirements for d.c. or a.c. supplied electronic ballasts. The supply comprises a.c. voltages up to 1000 V at 50 Hz/60 Hz. This part of IEC 61347 specifies safety requirements for electronic controlgear for use on AC supplies at 50 Hz or 60 Hz up to 1 000 V or DC supplies up to 1 000 V. The type of ballast controlgear is a convertor that may can contain igniting and stabilizing elements for operation of a discharge lamp under direct current or at a frequency that can deviate from the supply frequency. NOTE Lamps associated with the ballast this type of controlgear are specified in IEC 60188 (High pressure mercury vapour lamps), IEC 60192 (Low pressure sodium vapour lamps), IEC 60662 (High pressure sodium vapour lamps), IEC 61167 (Metal halide lamps) and else for general purpose lighting. Ballasts for fluorescent lamps and for lamps for special applications like for theatre and for vehicles are excluded. Controlgear for fluorescent lamps and for lamps for special applications such as theatre and vehicles are excluded.
Contents:
- FOREWORD
- INTRODUCTION
- Scope