Wind energy generation systems – Part 12-1: Power performance measurements of electricity producing wind turbines
Introduction: IEC TC 88 has made this third edition in order to reduce the complexity of the previous edition. Wind measurement procedures have been extracted from the performance standard, recognizing that wind measurements need to be referenced from other standards, such as in loads, noise and resource assessment measurements. IEC TC 88 recommends that the restructured standards gradually take over the previous standards before Maintenance Cycle Reports are written on the restructured standards introducing new technical requirements. Revision of the restructured documents should be proposed at the same time to incorporate such technical changes, recommendations, clarifications and simplifications. The purpose of the IEC 61400-12 series is to provide a uniform methodology that will ensure consistency, accuracy and reproducibility in the measurement and analysis of power performance by wind turbines. This document has been prepared with the anticipation that it would be applied by: a) a wind turbine manufacturer striving to meet well-defined power performance requirements and/or a possible declaration system; b) a wind turbine purchaser in specifying such performance requirements; c) a wind turbine operator who can be required to verify that stated, or required, power performance specifications are met for new or refurbished units; d) a wind turbine planner or regulator who needs to be able to accurately and fairly define power performance characteristics of wind turbines in response to re
Scope: This part of IEC 61400 specifies a procedure for measuring the power performance characteristics of a single wind turbine and applies to the testing of wind turbines of all types and sizes connected to the electrical power network. In addition, this document defines a procedure to be used to determine the power performance characteristics of small wind turbines (as defined in IEC 61400-2) when connected to either the electric power network or a battery bank. The procedure can be used for performance evaluation of specific wind turbines at specific locations, but equally the methodology can be used to make generic comparisons between different wind turbine models or different wind turbine settings when site-specific conditions and data filtering influences are taken into account. Considerations which can be of relevance to the assessment of uncertainty of power performance tests on multiple turbines are presented in Annex R on an informative basis. This document defines a measurement methodology that requires the measured power curve and derived energy production figures to be supplemented by an assessment of uncertainty sources and their combined effects. Uncertainty sources of wind measurements are assessed from procedures described in the relevant wind measurement equipment standards while uncertainty of the power curve and annual energy production are assessed by procedures in this document.
Contents:
- FOREWORD
- INTRODUCTION
- Scope