IEC 61400-13-2021 PDF

IEC 61400-13-2021 PDF

Wind turbines-Part 13: Measurement of mechanical loads

$472.88 $945.75 -50%
Product Code: IEC 61400-13
Stock In Stock
Edition: 1.1
Published: 12/2021
Number of Pages: 450
File Size: 1 file, 6 Bytes

Available Options

Product Description

Wind turbines – Part 13: Measurement of mechanical loads

Introduction: In the process of structural design of a wind turbine, thorough understanding about, and accurate quantification of, the loading is of utmost importance. In the design stage, loads can be predicted with aeroelastic models and codes. However, such models have their shortcomings and uncertainties, and they always need to be validated by measurement. Mechanical load measurements can be used both as the basis for design and as the basis for certification. Design aspects for wind turbines are covered by IEC 61400-1 whilst certification procedures are described in IEC 61400-22. This standard is aimed at the test institute, the turbine manufacturer and the certifying body and clearly defines the minimum requirements for a mechanical loads test resulting in consistent, high quality reproducible test results. INTRODUCTION to Amendment 1 This amendment to IEC 61400-13:2015 addresses the errors found in Annex B which impact a significant portion of that annex.

Scope: This part of the IEC 61400 describes the measurement of fundamental structural loads on wind turbines for the purpose of the load simulation model validation. The standard prescribes the requirements and recommendations for site selection, signal selection, data acquisition, calibration, data verification, measurement load cases, capture matrix, post-processing, uncertainty determination and reporting. Informative annexes are also provided to improve understanding of testing methods. The methods described in this document can also be used for mechanical loads measurements for other purposes such as obtaining a measured statistical representation of loads, direct measurements of the design loads, safety and function testing, or measurement of component loads. If these methods are used for an alternative objective or used for an unconventional wind turbine design, the required signals, measurement load cases, capture matrix, and post processing methods should be evaluated and if needed adjusted to fit the objective. These methods are intended for onshore electricity-generating, horizontal-axis wind turbines (HAWTs) with rotor swept areas of larger than 200 m2. However, the methods described may be applicable to other wind turbines (for example, small wind turbines, ducted wind turbines, vertical axis wind turbines).

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 61400-13-2021 PDF

IEC 61400-13-2021 PDF

$472.88 $945.75