IEC 61400-27-2-2020 PDF

IEC 61400-27-2-2020 PDF

Wind energy generation systems - Part 27-2: Electrical simulation models - Model validation

$311.50 $623.00 -50%
isbn 9782832210087
Product Code: IEC 61400-27-2
Stock In Stock
Edition: 1.0
Published: 07/01/2020
Number of Pages: 126
File Size: 1 file, 2 Bytes

Available Options

Product Description

Wind energy generation systems - Part 27-2: Electrical simulation models - Model validation

Introduction: IEC 61400-27-2 specifies model validation procedures for electrical simulation models of wind turbines and wind power plants. The increasing penetration of wind energy in power systems implies that Transmission System Operators (TSOs) and Distribution System Operators (DSOs) need to use dynamic models of wind power generation for power system stability studies. The purpose of this International Standard is to specify validation procedures for dynamic models, which can be applied in power system stability studies. The IEEE/CIGRE Joint Task Force on Stability Terms and Definitions [1]1 has classified power system stability in categories according to Figure 1. Figure 1 – Classification of power system stability according to IEEE/CIGRE Joint Task Force on Stability Terms and Definitions [1] Referring to these categories, the models to be validated have been developed to represent wind power generation in studies of large-disturbance short term stability phenomena, i.e. short term voltage stability, short term frequency stability and short term transient stability studies referring to the definitions of IEEE/CIGRE Joint Task Force on Stability Terms and Definitions in Figure 1. Thus, the models are applicable for dynamic simulations of power system events such as short-circuits (low voltage ride through), loss of generation or loads, and system separation of one synchronous area into more synchronous areas. The validation procedure specified in this document assesses the accuracy

Scope: This part of IEC 61400 specifies procedures for validation of electrical simulation models for wind turbines and wind power plants, intended to be used in power system and grid stability analyses. The validation procedures are based on the tests specified in IEC 61400-21 (all parts). The validation procedures are applicable to the generic models specified in IEC 61400-27-1 and to other fundamental frequency wind power plant models and wind turbine models. The validation procedures for wind turbine models focus on fault ride through capability and control performance. The fault ride through capability includes response to balanced and unbalanced voltage dips as well as voltage swells. The control performance includes active power control, frequency control, synthetic inertia control and reactive power control. The validation procedures for wind turbine models refer to the tests specified in IEC 61400-21-1. The validation procedures for wind turbine models refer to the wind turbine terminals. The validation procedures for wind power plant models is not specified in detail because IEC 61400-21-2 which has the scope to specify tests of wind power plants is at an early stage. The validation procedures for wind power plant models refer to the point of connection of the wind power plant. The validation procedures specified in IEC 61400-27-2 are based on comparisons between measurements and simulations, but they are independent of the choice of software simulation tool.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 61400-27-2-2020 PDF

IEC 61400-27-2-2020 PDF

$311.50 $623.00