IEC 61400-3-2-2025 PDF

IEC 61400-3-2-2025 PDF

Wind energy generation systems-Part 3-2: Design requirements for floating offshore wind turbines

$299.49 $598.97 -50%
Product Code: IEC 61400-3-2
Stock In Stock
Edition: 1.0
Published: 01/2025
Number of Pages: 350
File Size: 1 file, 6 Bytes

Available Options

Product Description

Wind energy generation systems – Part 3-2: Design requirements for floating offshore wind turbines

Introduction: This part of IEC 61400 outlines the minimum design requirements for floating offshore wind turbines (FOWT) and is not intended for use as a complete design specification or instruction manual. Several different parties may be responsible for undertaking the various elements of the design, manufacture, assembly, installation, erection, commissioning, operation and maintenance of a FOWT and for ensuring that the requirements of this document are met. The division of responsibility between these parties is a contractual matter and is outside the scope of this document. Any of the requirements of this document may be altered if it can be suitably demonstrated that the safety of the system is not compromised. Compliance with this document does not relieve any person, organization, or corporation from the responsibility of observing other applicable regulations.

Scope: This part of IEC 61400 specifies requirements for assessment of the external conditions at a floating offshore wind turbine (FOWT) site and specifies essential design requirements to ensure the engineering integrity of FOWTs. Its purpose is to provide an appropriate level of protection against damage from all anticipated hazards during the planned lifetime. This document focuses on the engineering integrity of the structural components of a FOWT but is also concerned with subsystems such as control and protection mechanisms, internal electrical systems and mechanical systems. A wind turbine shall be considered as a FOWT if the floating substructure is subject to hydrodynamic loading and supported by buoyancy and a stationkeeping system. A FOWT encompasses five principal subsystems: the RNA, the tower, the floating substructure, the stationkeeping system and the onboard machinery, equipment and systems that are not part of the RNA. The following types of floating substructures are explicitly considered within the context of this document: ship-shaped structures and barges, semi-submersibles (Semi), spar buoys (Spar), tension-leg platforms/buoys (TLP / TLB). This document can be utilized for structural types other than listed above, but special consideration may be needed to support novel features to achieve the same target safety level. These other structures can have a great range of variability in geometry, materials and structural forms and, therefore, can be only partly covered by the requirements of this document. In other cases, specific requirements stated in this document can be found not to apply to all or part of a structure under design. In all the above cases, conformity with this document will require that the design is based upon its underpinning principles and achieves a level of safety equivalent, or superior, to the level implicit in it. This document is applicable to unmanned floating structures with one single horizontal axis turbine. While generally applicable, additional considerations may be needed, e.g., for multi- turbine units on a single floating substructure, vertical-axis wind turbines, FOWTs with shared moorings, spinning spars, float

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 61400-3-2-2025 PDF

IEC 61400-3-2-2025 PDF

$299.49 $598.97