Functional safety of electrical/electronic/programmable electronic safety-related systems – Part 1: General requirements
Introduction: Systems comprised of electrical and/or electronic elements have been used for many years to perform safety functions in most application sectors. Computer-based systems (generically referred to as programmable electronic systems) are being used in all application sectors to perform non-safety functions and, increasingly, to perform safety functions. If computer system technology is to be effectively and safely exploited, it is essential that those responsible for making decisions have sufficient guidance on the safety aspects on which to make these decisions. This International Standard sets out a generic approach for all safety lifecycle activities for systems comprised of electrical and/or electronic and/or programmable electronic (E/E/PE) elements that are used to perform safety functions. This unified approach has been adopted in order that a rational and consistent technical policy be developed for all electrically-based safety-related systems. A major objective is to facilitate the development of product and application sector international standards based on the IEC 61508 series. NOTE 1 Examples of product and application sector international standards based on the IEC 61508 series are given in the Bibliography (see references [1], [2] and [3]). In most situations, safety is achieved by a number of systems which rely on many technologies (for example mechanical, hydraulic, pneumatic, electrical, electronic, programmable electronic). Any safety strategy must therefore c
Scope: 1.1 This International Standard covers those aspects to be considered when electrical/electronic/programmable electronic (E/E/PE) systems are used to carry out safety functions. A major objective of this standard is to facilitate the development of product and application sector international standards by the technical committees responsible for the product or application sector. This will allow all the relevant factors, associated with the product or application, to be fully taken into account and thereby meet the specific needs of users of the product and the application sector. A second objective of this standard is to enable the development of E/E/PE safety-related systems where product or application sector international standards do not exist. 1.2 In particular, this standard a) applies to safety-related systems when one or more of such systems incorporates electrical/electronic/programmable electronic elements; NOTE 1 In the context of low complexity E/E/PE safety-related systems, certain requirements specified in this standard may be unnecessary, and exemption from compliance with such requirements is possible (see 4.2, and the definition of a low complexity E/E/PE safety-related system in 3.4.3 of IEC 61508-4). NOTE 2 Although a person can form part of a safety-related system (see 3.4.1 of IEC 61508-4), human factor requirements related to the design of E/E/PE safety-related systems are not considered in detail in this standard. b) is generically-based and applicable to all E/E/PE safety-related systems irrespective of the application; c) covers the achievement of a tolerable risk through the application of E/E/PE safety-related systems, but does not cover hazards arising from the E/E/PE equipment itself (for example electric shock); d) applies to all types of E/E/PE safety-related systems, including protection systems and control systems; e) does not cover E/E/PE systems where a single E/E/PE system is capable on its own of meeting the tolerable risk, and the required safety integrity of the safety functions of the single E/E/PE system is less than that specified for safety integrity level 1 (the lowest safety integrity level in this standard). f) is m
Contents:
- FOREWORD
- INTRODUCTION
- Scope
- Introduction
- 7.10 E/E/PE system safety requirements specification
- 7.10.1 Objective
- 7.10.2 Requirements
- 7.11 E/E/PE safety-related systems – realisation