IEC 61558-2-23 EXV-2024 PDF

IEC 61558-2-23 EXV-2024 PDF

Safety of transformers, reactors, power supply units and combinations thereof-Part 2-23: Particular requirements and tests for transformers and power supply units for construction sites (Extended Version)

$509.45 $1,018.89 -50%
Product Code: IEC 61558-2-23 EXV
Stock In Stock
Edition: 3.0
Published: 06/2024
Number of Pages: 228
File Size: 1 file

Available Options

Product Description

Safety of transformers, reactors, power supply units and combinations thereof – Part 2-23: Particular requirements and tests for transformers and power supply units for construction sites (Extended Version)

Scope: This part of IEC 61558 deals with the safety of transformers for construction sites and power supply units incorporating transformers for construction sites. Transformers incorporating electronic circuits are also covered by this document. NOTE 1 Safety includes electrical, thermal and mechanical aspects. Unless otherwise specified, from here onward, the term transformer covers transformers for construction sites and power supply units incorporating transformers for construction sites. This document is applicable to stationary or portable, single-phase or polyphase, air-cooled (natural or forced) independent or associated transformers, being isolating or safety isolating dry-type transformers for the use on construction sites. The windings can be encapsulated or non-encapsulated. For power supply units (linear) this document is applicable. For switch mode power supply units, IEC 61558-2-16 is applicable together with this document. Where two requirements are in conflict, the most severe takes precedence. The rated supply voltage does not exceed 1 000 V AC, and the rated supply frequency and the internal operating frequencies do not exceed 500 Hz. The rated output does not exceed: 25 kVA for single-phase transformers; 40 kVA for polyphase transformers. This document is applicable to transformers without limitation of the rated output subject to an agreement between the purchaser and the manufacturer. NOTE 2 Transformers intended to supply distribution networks are not included in the scope. Isolating transformers for construction sites have a no-load output voltage and a rated output voltage exceeding 50 V AC and not exceeding 250 V AC. Safety isolating transformers for construction sites have a no-load output voltage and a rated output voltage not exceeding 50 V AC. NOTE 3 This document is applicable to transformers for the supply of electricity in locations as specified in IEC 60364-7-704. The latter also specifies the protection by using an earthed midpoint or starpoint of the output winding. NOTE 4 Transformers covered by this document are used in applications where it is required by the installation rules or by the appliance specification for protection purp

Contents:

  • FOREWORD
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 61558-2-23 EXV-2024 PDF

IEC 61558-2-23 EXV-2024 PDF

$509.45 $1,018.89