Mechanical structures for electrical and electronic equipment – Tests for IEC 60917 and IEC 60297 series – Part 1: Environmental requirements, test setups and safety aspects
Introduction: This document provides a common methodology to perform and report conformance tests of IEC 60917 or IEC 60297 compliant cabinets, racks, subracks, chassis, chassis integrated subracks and associated plug-in units under indoor condition use and transportation conditions. Manufacturers can show the performance and characteristics of products in their catalogues by using the classifications in accordance with this document. Users get comparative figures to compare products of different producers and can choose products for their targeted system from their catalogues. With the information of different classification levels, they get important indices for the possible maximum loads of the enclosure, which are important for their individual and safe applicability. Designers of new products can define the performance requirements of these new products for their targeted systems by referencing this document. This allows a cost optimized design in accordance with the intended application. This edition 5 constitutes a revision of the previous edition, with the following changes: a) Subracks, chassis with integrated subracks and associated plug-in units The static mechanical tests of subracks as described in edition 4 were based on the inspection of load bearing structural parts (single point load). On the other hand, the dynamic mechanical load test in edition 4 described not only subracks but also various types of chassis with integrated subracks, based on the load categories. In addi
Scope: This part of IEC 61587 specifies environmental requirements, test set-ups, as well as safety aspects for empty enclosures, i.e. cabinets, racks, subracks, chassis, chassis integrated subracks and associated plug-in units under indoor condition use and transportation. It defines classifications (product performance levels) for these products, regarding and simulating the usually arising loads during their use. For mechanical static and dynamic load tests typical examples with dummy loads are used. The purpose of this document is to establish defined levels of physical performance in order to meet certain requirements of manufacture, storage, transport and final location conditions. This document applies in general only to the above cited mechanical structures.
Contents:
- FOREWORD
- INTRODUCTION
- Scope