IEC 61587-2-2011 PDF

IEC 61587-2-2011 PDF

Mechanical structures for electronic equipment-Tests for IEC 60917 and IEC 60297-Part 2: Seismic tests for cabinets and racks

$50.44 $100.88 -50%
Product Code: IEC 61587-2
Stock In Stock
Edition: 2.0
Published: 08/2011
Number of Pages: 32
File Size: 1 file, 1 Byte

Available Options

Product Description

Mechanical structures for electronic equipment – Tests for IEC 60917 and IEC 60297 – Part 2: Seismic tests for cabinets and racks

Introduction: Edition 1.0 of this standard specified the seismic test for the cabinets or racks according to IEC 60297 and IEC 60917. The specified test applied to the structure of the enclosure and did not apply to the whole system. Edition 1.0 specified the test condition with one size of the cabinet, and one load distribution. The specified acceleration condition for the test specimen was single-axis and one of the RRS (required response spectra) specified in the standard was selected. The test was aimed to obtain the reference for the structural strength of the enclosure against the specified seismic intensity. The electronic system consists of two or more subracks. Two or more plug-in units that perform signal processing are installed in each subrack. The size, i.e.: height, width and depth, and the weight of each subrack may vary for each electronic system. So, various types of cabinets or racks to equip the electronic system are currently demanded. Therefore, many types of cabinets or racks are required to install the equipment. Earthquakes are actually random phenomena that are much more carefully simulated by tri- axial simultaneous operation. The demand of tri-axial excitation has emerged as a more accurate representation of an earthquake. Edition 2.0 of this standard has been reviewed in consideration of these demanded conditions. However, it is impossible to perform the seismic test under all of the cabinet or rack conditions. The aim of this standard is then to evaluate the re

Scope: This part of IEC 61587 specifies seismic tests for cabinets and racks accommodated with IEC 60917 and 60297 series. It applies, in whole or in part, only to the mechanical structures of cabinets and racks for electronic equipment according to the above cited series of standards, while it does not apply to the electronic equipment or systems deemed to be installed within these mechanical structures. This standard does not apply either to a cabinet or a rack having an anti-seismic isolation structure, either external or internal. This standard aims to provide test conditions and criteria that constitute a reference to evaluate the ability of the mechanical structure of the cabinets or racks to acceptably withstand specified seismic intensities. For this purpose, this standard specifies test specimen conditions, such as dimensions (i.e. height, width and depth) of the cabinet and the rack, load distribution, structural test condition and the RRS (required response spectra) of single- axis or tri-axis acceleration as the seismic test wave condition. The single-axis or tri-axis acceleration is selectable.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 61587-2-2011 PDF

IEC 61587-2-2011 PDF

$50.44 $100.88