Low voltage surge protective devices - Part 21: Surge protective devices connected to telecommunications and signalling networks - Requirements and test methods
Introduction: It has been assumed in the drafting of this International Standard that the execution of its provisions is entrusted to appropriately qualified and experienced persons. This document recognizes the internationally accepted level of protection against hazards such as electrical, mechanical, thermal, fire and radiation of SPDs when operated as in normal use taking into account the manufacturer's instructions. The purpose of this document is to identify the requirements for Surge Protective Devices (SPDs) used in protecting telecommunications and signalling networks, for example, low- voltage data, voice, and alarm circuits. If the intended applications of an SPD are covered by different parts of the IEC 61643-X1 series, all relevant parts are applied. This part of the IEC 61643 series addresses safety and performance tests for surge protective devices (SPDs) for telecommunications and signalling networks in conjunction with IEC 61643-01:2024. This document addresses SPDs containing voltage-limiting components only, or a combination of voltage-limiting components and current-limiting components. Protection devices containing current-limiting components only are not within the coverage of this document. This document covers a wide range of testing conditions and requirements; the use of some of these is at the discretion of the user. How the requirements of this document relate to the different types of SPD is described in Table 100. Selection and application principles are cover
Scope: This document, together with IEC 61643-01:2024, is applicable to devices for surge protection against indirect and direct effects of lightning or other transient overvoltages. These devices are intended to be connected to telecommunications and signalling networks, and equipment rated up to 1 000 V RMS and 1 500 V DC. These telecommunications and signalling networks can also provide power on the same line, e.g. Power over Ethernet (PoE). Performance and safety requirements, tests and ratings are specified in this document. These devices contain at least one voltage-limiting component (clamping or switching) and are intended to limit surge voltages and divert surge currents.
Contents:
- FOREWORD
- INTRODUCTION
- Scope
- 4.100 SPD configurations
- 4.101 SPD Variants
- 4.102 Overstressed fault mode according to 3.1.115
- 4.103 Additional information about transmission and special applications