IEC 61643-22-2015 PDF

IEC 61643-22-2015 PDF

Low-voltage surge protective devices - Part 22: Surge protective devices connected to telecommunications and signalling networks - Selection and application principles

$239.59 $479.18 -50%
Product Code: IEC 61643-22
Stock In Stock
Edition: 2.0
Published: 06/2015
Number of Pages: 134
File Size: 1 file, 1 Byte

Available Options

Product Description

Low-voltage surge protective devices - Part 22: Surge protective devices connected to telecommunications and signalling networks - Selection and application principles

Introduction: This International Standard is a guide for the application of SPDs to telecommunications and signalling lines and those SPDs which have telecom or signalling SPDs in the same enclosure with power line SPDs (so called multiservice SPDs). Definitions, requirements and test methods are given in IEC 61643-21. The decision to use SPDs is based on an analysis of the risks that are seen by the network or system under consideration. Because telecommunications and signalling systems may depend on long lengths of wire, either buried or aerial, the exposure to overvoltages from lightning, power line faults and power line/load switching, can be significant. If these lines are unprotected, the resultant risk to information technology equipment (ITE) can also be significant. Other factors that may influence the decision to use SPDs are local regulators and insurance stipulations. This standard provides indications for evaluating the need for SPDs, the selection, installation and dimensioning of SPDs and for achieving coordination between SPDs and between SPDs and ITE installed on telecommunication and signal lines. Coordination of SPDs assures that a proper interaction between them, as well as between an SPD and the ITE to be protected will be realized. Coordination requires that the voltage protection level, Up, and let-through current, Ip, of the initial SPD does not exceed the resistibility of subsequent SPDs or the ITE. In general, the SPD closest to the source of the impinging surge d

Scope: This part of IEC 61643 describes the principles for the selection, operation, location and coordination of SPDs connected to telecommunication and signalling networks with nominal system voltages up to 1 000 V r.m.s. a.c. and 1 500 V d.c. This standard also addresses SPDs that incorporate protection for signalling lines and power lines in the same enclosure (so called multiservice SPDs).

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 61643-22-2015 PDF

IEC 61643-22-2015 PDF

$239.59 $479.18