IEC 61685-2001 PDF

IEC 61685-2001 PDF

Ultrasonics - Flow Measurement Systems - Flow Test Object

$163.93 $327.86 -50%
Product Code: IEC 61685
Stock In Stock
Edition: 1.0
Published: 07/2001
Number of Pages: 42
File Size: 1 file, 221 Bytes

Available Options

Product Description

Ultrasonics - Flow Measurement Systems - Flow Test Object

Introduction: The purpose of this International Standard is to establish a flow Doppler test object for the acceptance testing, quality assurance testing and clinical calibration of Doppler systems, working at a frequency between 2 MHz and 10 MHz. As the response of Doppler systems depends on the signal level and on the spectral contents of the signal, it is desirable to test some aspects of a Doppler system with a test object that mimics the in vivo situation. A flow Doppler test object is particularly useful for testing the influence of the size and the depth of the blood vessel on the signal recorded by a Doppler system; testing the response of a Doppler system with a spectrum of blood velocities typical of the in vivo situation. This flow test object is not intended as a phantom mimicking clinical conditions. The basis of this International Standard is given by IEC Technical Report 61206:1993 Ultrasonics – Continuous Wave Doppler systems – Test procedures. In annex A the position of this standard in relation to IEC 61206 and IEC 61895 is described. This standard only declares parameters that can be measured with the test object. Measurement methods are given in IEC 61206 and IEC 61895. This International Standard deals only with the flow Doppler test object in a restricted sense, i.e. the section in which the ultrasonic measurements are performed. Where the whole of the set-up is meant, the phrase 'flow rig' is used. The prescriptions of this International Standard define the ultrasoni

Scope: This International Standard specifies parameters for a flow Doppler test object representing a blood vessel of known diameter at a certain depth in human tissue, carrying a steady flow. This International Standard establishes a flow Doppler test object which can be used to assess various aspects of the performance of Doppler diagnostic equipment.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 61685-2001 PDF

IEC 61685-2001 PDF

$163.93 $327.86