Liquid crystal display devices – Part 30-1: Measuring methods for liquid crystal display modules – Transmissive type
Introduction: In order to achieve a useful and uniform description of the performance of liquid crystal display (LCD) devices, specifications for commonly accepted relevant parameters are put forward. These fall into the following categories: a) general type specification (e.g. pixel resolution, diagonal, pixel layout); b) optical specification (e.g. contrast ratio, response time, viewing-direction, crosstalk, etc.); c) electrical specification (e.g. power consumption, electromagnetic compatibility); d) mechanical specification (e.g. module geometry, weight); e) specification of passed environmental endurance test; f) specification of reliability and hazard / safety. In most of the cases a) to f), the specification is self-explanatory. For some specification points however, notably in the area of optical and electrical performance, the specified value may depend on the measuring method. The purpose of this standard is to indicate and list the procedure-dependent parameters and to prescribe the specific methods and conditions that are to be used for their uniform numerical determination. It is assumed that all measurements are performed by personnel skilled in the general art of radiometric and electrical measurements as the purpose of this standard is not to give a detailed account of good practice in electrical and optical experimental physics. Furthermore, it shall be assured that all equipment is suitably calibrated as is known to people skilled in the art and records of the calibration
Scope: This part of IEC 61747 is restricted to transmissive liquid crystal display-modules using either segment, passive or active matrix and achromatic or colour type LCDs. Furthermore, the transmissive modes of transflective LCD modules with backlights ON are comprised in this document. An LCD module in combination with a touch-panel or a front-light-unit is excluded from the scope because measurements are frequently inaccurate. Touch-panels or front-light- units are removed before measurement. Throughout the main body of this standard, an integrated backlight is assumed to provide the illumination for the measurements. Deviations from this (e.g. segmented displays without integrated backlights) may usually be handled in the same way as display modules with integrated backlight, if an external backlight is provided. However, in the case where one of the two situations should be handled differently, this will be specifically stated.
Contents:
- FOREWORD
- INTRODUCTION
- Scope