Fibre optic connector interfaces – Part 25: Type RAO connector family
Introduction: International Electrotechnical Commission (IEC) draws attention to the fact that it is claimed that compliance with this document may involve the use of a patent concerning IEC 61754-25. IEC takes no position concerning the evidence, validity and scope of this patent right. The holder of this patent right has assured IEC that he/she is willing to negotiate licences under reasonable and non-discriminatory terms and conditions with applicants throughout the world. In this respect, the statement of the holder of this patent right is registered with IEC. Information may be obtained from: Intellectual Property Management Business Department NTT Advance Technology Corporation Musashino-center Bidg,1-19-18 Nakamachi Musashino-Shi, Tokyo Japan R&D Department Sanwa Denki Kogyo Co.,Ltd 2973-4,Ishikawa-Cho,Hachioji-Shi, Tokyo Japan Intellectual Property Department Nippon Telegraph and Telephone Corporation 9-11, Midori-Cho 3-Chome, Musashino-Shi, Tokyo Japan NTT Advance Technology Corporation and Sanwa Denki Kogyo hold the patent right concerning Figure 1A (patent number:2001-318847). NTT holds the patent right concerning Figure 2A and Figure 3 (patent number: 1991-228619). Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights other than those identified above. IEC shall not be held responsible for identifying any or all such patent rights.
Scope: This part of IEC 61754 defines the standard interface dimensions for the type RAO family of connectors. Description The type RAO connector is a multiway right-angled optical board connector, for glass optical fibre, which connects two optical boards or provides a connection between an optical fibre ribbon and an optical board at an angle of 90°. The optical connection is the physical contact of optical fibres with rectangular ferrules nominally 6,4 mm x 2,5 mm, which use two 0,7 mm diameter alignment pins. The radius of curvature at the 90° bend is maintained so that it gives permissible loss. Interfaces This standard contains the following standard interfaces: Figure 1a: RAO connector configuration (top view) Figure 1b: RAO connector configuration (side view) Figure 2a: RAO socket connector interface Figure 2b: Optical datum target location diagrams Figure 3: RAO plug connector Table 1: Dimensions of the RAO socket connector interface Table 2: Dimensions of the RAO plug connector interface – 16 – 61754-25 © CEI:2008 AVANT-PROPOS..................................................................................................................17 INTRODUCTION...................................................................................................................19 Domaine d'application ....................................................................................................20 Description .....................................................................................................................20 Interfaces .......................................................................................................................20 Figure 1 – Configuration du connecteur RAO ........................................................................21 Figure 2 – Socle de connecteur RAO ....................................................................................24 Figure 3 – Fiche de connecteur RAO ....................................................................................27 Tableau 1 – Dimensions de l'interface du socle de connecteur RAO .....................................25 Tableau 2 – Dimensions de l’interface de la fiche d
Contents:
- FOREWORD
- INTRODUCTION
- Scope