IEC 61788-22-3-2022 PDF

IEC 61788-22-3-2022 PDF

Superconductivity-Part 22-3: Superconducting strip photon detector-Dark count rate

$100.88 $201.76 -50%
Product Code: IEC 61788-22-3
Stock In Stock
Edition: 1.0
Published: 08/2022
Number of Pages: 54
File Size: 1 file, 3 Bytes

Available Options

Product Description

Superconductivity – Part 22-3: Superconducting strip photon detector – Dark count rate

Introduction: IEC 61788-22 (all parts) is a series of International Standards on superconductor electronic devices. Superconductivity enables ultra-sensitive sensing or detection of a variety of measurands. IEC 61788-22-1 [1]1 lists various types of superconductor sensors and detectors. The strip type in this document is one of them. A typical fundamental structure of strip type detectors is a meander superconductor line, for example, with a thickness of less than 10 nm, a width of less than 100 nm or a few 100 nm, and a length of a few mm. The structure is in the nanoscale. ISO TS 80004-2:2015 [2] defines the nanoscale as a length range approximately from 1 nm to 100 nm. Because nano-objects have one or two dimensions in the nanoscale, superconductor meander lines are categorized as a nano-object. The term "nanowire" is frequently used for superconductor meander lines, but it is not recommended in this document. In the ISO vocabulary, a nanowire is defined as an electrically conducting or semi-conducting nanofibre with two external dimensions in the nanoscale, with the third dimension being significantly larger. The two external dimensions of the nanowires are in the nanoscale range, approximately from 1 nm to 100 nm. When the first two dimensions differ significantly, a "nanoplate," "nanoribbon," or "nanotape" shall be used for the meander line shape. However, in the field of electronics, these terms are not common. In addition to the ISO definition of nano-objects, the shape of the supe

Scope: This part of IEC 61788 is applicable to the measurement of the dark count rate (DCR, RD) of superconductor strip photon detectors (SSPDs). It specifies terms, definitions, symbols and the measurement method of DCR that depends on the bias current (Ib) and operating temperature (T). NOTE The data of measurement results in Annex A are based on measurements of one institute only. The standard will be updated after the data of a complete round robin test are available.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 61788-22-3-2022 PDF

IEC 61788-22-3-2022 PDF

$100.88 $201.76