IEC 61892-2-2019 PDF

IEC 61892-2-2019 PDF

Mobile and fixed offshore units-Electrical installations-Part 2: System design

$255.36 $510.71 -50%
Product Code: IEC 61892-2
Stock In Stock
Edition: 3.0
Published: 04/2019
Number of Pages: 238
File Size: 1 file, 5 Bytes

Available Options

Product Description

Mobile and fixed offshore units – Electrical installations – Part 2: System design

Introduction: IEC 61892 forms a series of International Standards for safety in the design, selection, installation, maintenance and use of electrical equipment for the generation, transmission, storage, distribution and utilization of electrical energy for all purposes in offshore units which are used for the purpose of exploration or exploitation of petroleum resources. This part of IEC 61892 incorporates and coordinates, as far as possible, existing rules and forms a code of interpretation, where applicable, of the requirements of the International Maritime Organization (IMO), and constitutes a guide for future regulations which may be prepared and a statement of practice for offshore unit owners, designers, installers and appropriate organizations. This document is based on solutions and methods which are in current use, but it is not intended to impede the development of new or improved techniques. In this revision, voltage limitations have been removed. However, voltage limitations may be given in the referenced equipment standards. The removal of voltage limitations is considered necessary due to the interconnection of, and supply from shore to offshore units. In such cases, transmission voltages up to 132 kV AC and 150 kV DC are used and higher voltages are being planned. The IEC 61892 series aims to constitute a set of International Standards for the offshore petroleum industry, but it is not intended to prevent their use beyond petroleum installations.

Scope: This part of IEC 61892 is applicable to system design of electrical installations and equipment in mobile and fixed offshore units including pipeline, pumping or "pigging" stations, compressor stations and single buoy moorings, used in the offshore petroleum industry for drilling, production, accommodation, processing, storage and offloading purposes. It applies to all installations, whether permanent, temporary, transportable or hand-held, to AC installations and DC installations, without any voltage level limitation. Referenced equipment standards may give voltage level limitations. This document specifies requirements such as those concerning sources of electrical power for manned and unmanned units, system earthing, both for low-voltage and high-voltage installations, interface for electric transmission systems with power supplied from shore, between interconnected offshore units, and with power supplied by offshore units to subsea installations, distribution systems, cables and wiring systems, system studies and calculations, protection against electrical faults, lighting, energy control, monitoring and alarm systems, and turret/swivel. This document gives information and guidance on topics such as applicable examples of HVDC VSC technology, and guidelines for illumination level. This document does not apply to fixed equipment for medical purposes, electrical installations of tankers, and control of ignition sources other than those created by electrical equipment. NOTE 1 For medical rooms, IEC 60364-7-710 provides specific requirements. Requirements for tankers are given in IEC 60092-502. NOTE 2 Guidance on protection of non-electrical equipment can be found in ISO 80079-36, ISO 80079-37 and IMO 2009 MODU Code, 6.7. – 12 – IEC 61892-2:2019 © IEC 2019

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 61892-2-2019 PDF

IEC 61892-2-2019 PDF

$255.36 $510.71