IEC 61966-7-1-2006 PDF

IEC 61966-7-1-2006 PDF

Multimedia systems and equipment-Colour measurement and management-Part 7-1: Colour printers-Reflective prints-RGB inputs

$186.00 $371.99 -50%
Product Code: IEC 61966-7-1
Stock In Stock
Edition: 2.0
Published: 05/2006
Number of Pages: 48
File Size: 1 file, 981 Bytes

Available Options

Product Description

Multimedia systems and equipment – Colour measurement and management – Part 7-1: Colour printers – Reflective prints – RGB inputs

Introduction: This part of IEC 61966 is applicable to characterization of colour printers that produce colour on opaque substrate corresponding to digital data files in which colour image information is expressed in a red–green–blue colour space. The characterization will be realized by objective measurements to be utilized for colour management in open systems. The measured and reported results are used to relate the equipment-dependent and undefined red –green–blue colour space to the default RGB colour space defined as the sRGB by IEC 61966-2-1. This standard is also applicable to assessment of colour image attributes on reflective prints reproduced from colour digital image files. The recommended usage of the standard is for evaluation of the output of home and office RGB printers.

Scope: This part of IEC 61966 specifies a set of data in colour test chart files for measurements, sampling of successive prints, measurement conditions and forms of reporting the results so as to make possible the characterization of the colour printer and comparison of the results of measurements. The sets of data for measurements are in colour test chart files expressed in a red–green–blue colour space, to which corresponding colour images are reproduced on reflective substrate. The methods of measurement in this standard are designed to be applicable to reflective colour prints for consumer use. The reflective colour prints may be produced by non-impact colour printers, incorporating such technologies as ink-jet, sublimation transfer, thermal transfer, electro-photography and other similar technologies. This standard does not specify limiting values for various attributes.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope
  • 10 Temporal instability characteristics
  • 10.1 Short-term instability
  • 10.2 Long-term instability
  • 11 Dependency on illuminant characteristics

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 61966-7-1-2006 PDF

IEC 61966-7-1-2006 PDF

$186.00 $371.99