Secondary Batteries for the Propulsion of Electric Road Vehicles - Part 3: Performance and Life Testing (Traffic Compatible, Urban Use Vehicles
Introduction: The test cycles used in existing IEC standards for traction battery testing have been developed to confirm that batteries of the same type reach an acceptable standard of performance. The power levels have been based on the ampere hour capacity of the battery (W/Ah). The test procedures normally allow the results to be derived from tests on a small number of cells, in a constant temperature environment. The tests have specifically excluded the comparison of different battery electrochemistries for the same duty. The tests are not designed to give information about power capability, charge acceptance and partial discharge effects as a function of age, temperature, state of charge, etc. As a result, the standards are of limited use for traction battery selection when different battery types, whose characteristics can vary widely, could be chosen to power the same electric vehicle. The electric vehicle community has developed test cycles that reflect the actual operation of the battery in the vehicle more closely. The power levels have been based on the weight of the battery (W/kg), on the assumption that the proportion of battery weight to vehicle weight will be constant. The tests have given satisfactory results in the past since batteries have had similar characteristics and vehicles have had relatively modest performance. The situation is now quite different for a number of reasons: 1) Vehicle performances are increasing and the difference between the peak power and the aver
Scope: This part of IEC 61982 is applicable to performance and life testing of electrical energy storage systems for general purpose, traffic compatible, light urban use electric road vehicles that are designed for transportation of passengers or goods in city centre driving. For the purposes of this standard, the electrical energy storage system is defined as one that is recharged electrically though some of the test procedures may be applicable to fuel cells and other “mechanically” rechargeable systems. The test procedures may also be applicable to electrical energy storage systems used in some types of hybrid-electric vehicle though detailed consideration of electrical energy storage systems for hybrid vehicles will be addressed separately. This part of IEC 61982 is not applicable to systems for specialist vehicles such as public transport vehicles, refuse collection vehicles, scooters or large commercial vehicles. Standards relating to the test procedures for energy storage systems for these vehicles will be developed later as a supplement to this standard. The test procedures are defined as a function of the vehicle requirements and without reference to the actual composition of the electrical energy storage system under test. They will allow direct comparison between the performance of different types of electrical energy storage systems when used for the same duty. They will also allow direct comparison between the performances of the same type of electrical energy storage system with different capacities, when used for the same duty. Note that there are three fundamental tests i.e., tests for capacity (range), power (performance), and life. All other tests are optional. The results from the test programme are presented in the form of “performance achieved” and not in the form of “pass/fail”. NOTE Throughout this standard, the words “battery” or “battery system” are to be regarded as synonymous with the words “electrical energy storage system” since there are a number of ways in which electrical energy can be stored without the use of electrochemistry. Definitions For the purposes of this part of IEC 61982, the following definitions apply: 2.1 traffic compatibl
Contents:
- FOREWORD
- INTRODUCTION
- Scope
- 5.2.10 Measurement of self discharge
- 5.2.11 Capacity loss testing
- Introduction
- Introduction