IEC 62021-2-2007 PDF

IEC 62021-2-2007 PDF

Insulating liquids-Determination of acidity Part 2: Colourimetric titration

$50.44 $100.88 -50%
Product Code: IEC 62021-2
Stock In Stock
Edition: 1.0
Published: 05/2007
Number of Pages: 36
File Size: 1 file, 351 Bytes

Available Options

Product Description

Insulating liquids – Determination of acidity Part 2: Colourimetric titration

Introduction: The standardized method given in IEC 62021-1 is a method for measurement of acidity in used and unused mineral oil and is a potentiometric titration requiring special instrumentation for measurement of acidity. Historically, acidity of insulating oil was measured by colourimetric titration as described in IEC 60296, 1982 edition. With the revision of IEC 60296, the colourimetric titration was deleted as that method used high volumes of sample and solvent, generating undesirable volumes of waste. However, there is still a market requirement for having colourimetric titration as many labs use this method. Health and safety This International Standard does not purport to address all the safety problems associated with its use. It is the responsibility of the user of the Standard to establish appropriate health and safety practices and determine the applicability of regulatory limitations prior to use. The mineral oils which are the subject of this standard should be handled with due regard to personal hygiene. Direct contact with eyes may cause slight irritation. In the case of eye contact, irrigation with copious quantities of clean running water should be carried out and medical advice sought. Some of the tests specified in this standard involve the use of processes that could lead to a hazardous situation. Attention is drawn to the relevant standard for guidance. This standard involves mineral oils, chemicals and used sample containers. The disposal of these items should be c

Scope: This part of IEC 62021 describes a procedure for determination of the acidity of unused and used electrical mineral insulating oils. NOTE 1 In unused and used mineral insulating oils, the constituents that may be considered to have acidic characteristics include organic acids, phenolic compounds, some oxidation products, resins, organometallic salts and additives. The method may be used to indicate relative changes that occur in a mineral insulating oil during use under oxidizing conditions that may or may not be shown by other properties of the resulting mineral oil. The acidity can be used in the quality control of unused mineral oil. As a variety of oxidation products present in used mineral oil contribute to acidity and these products vary widely in their corrosion properties, the test cannot be used to predict corrosiveness of a mineral oil under service conditions. NOTE 2 The acidity results obtained by this test method may or may not be numerically the same as those obtained by potentiometric methods, but they are generally of the same magnitude. The potentiometric method uses an endpoint at pH 11,3 to ensure titration of all species, whereas the colourimetric methods uses an indicator changing colour at approximately pH 9,5. This may lead to slightly higher results for oils with acidities above 0,3 mg KOH/g oil when using the potentiometric method.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope
  • 10 Precision
  • 10.1 Repeatability
  • 10.2 Reproducibility
  • 11 Report

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 62021-2-2007 PDF

IEC 62021-2-2007 PDF

$50.44 $100.88