Low-voltage switchgear and controlgear – Controller-device interfaces (CDIs) – Part 3: DeviceNet
Introduction: DeviceNet™1 is intended for use in, but is not limited to, industrial automation applications. These applications may include devices such as limit switches, proximity sensors, electro- pneumatic valves, relays, motor starters, operator interface panels, analogue inputs, analogue outputs and controllers. _____________ DeviceNet™ is a trade name of ODVA, Inc. This information is given for the convenience of users of this International Standard and does not constitute an endorsement by IEC of the trademark holder or any of its products. Compliance to this standard does not require use of the trade name DeviceNet™. Use of the trade name DeviceNet™ requires permission of ODVA, Inc.
Scope: This part of IEC 62026 specifies an interface system between single or multiple controllers, and control circuit devices or switching elements. The interface system uses two conductor pairs within one cable – one of these pairs provides a differential communication medium and the other pair provides power to the devices. This part establishes requirements for the interoperability of components with such interfaces. This part of IEC 62026 specifies the following particular requirements for DeviceNet: requirements for interfaces between controllers and switching elements; normal service conditions for devices; constructional and performance requirements; tests to verify conformance to requirements. These particular requirements apply in addition to the general requirements of IEC 62026-1.
Contents:
- FOREWORD
- INTRODUCTION
- Scope