Electricity metering equipment – General requirements, tests and test conditions – Part 11: Metering equipment
Introduction: The general overview and organization of the IEC 6205x series of standards applicable to electricity metering and load control equipment is as follows: PRODUCT FAMILY STANDARDS – GENERAL REQUIREMENTS PRODUCT FAMILIES AC meters rated up to 1 000 V for direct connection or connection through conventional transformers Tariff and load control equipment DC meters rated up to 1 500 V for direct connection AC meters for connection through LPITs (as defined in the IEC 61869 series of standards) DC meters for connection through LPITs (as defined in the IEC 61869 series of standards) NOMINAL VALUES, CONSTRUCTION, ELECTRICAL, CLIMATIC AND EMC REQUIREMENTS. TEST METHODS IEC 62052‑11:2020 IEC 62052‑21 2004 IEC 62052‑11:2020 Planned: IEC 62052-XX general requirements for meters for connection through LPITs. SAFETY IEC 62052-31:2015 Planned: IEC 62052-31 2nd edition including safety requirements for DC meters Planned: IEC 62052-XX safety requirements for meters for connection through LPITs. DEPENDABILITY IEC 62059-11: 2002, IEC 62059- 21:2002, IEC 62059-32-1 2011, IEC 62059-41:2006 Planned: IEC 62059-XX dependability requirements for DC meters Planned: IEC 62059-XX dependability requirements for meters for connection through LPITs. ACCEPTANCE INSPECTION IEC 62058-11:2008 Planned: IEC 62058-XX acceptance inspection requirements for meters for connection through LPITs. EMBEDDED SOFTWARE Planned: IEC 6205x-xx embedded software (firmware) requirements and test methods for electricity metering a
Scope: This part of IEC 62052 specifies requirements and associated tests, with their appropriate conditions for type testing of AC and DC electricity meters. This document details functional, mechanical, electrical and marking requirements, test methods, and test conditions, including immunity to external influences covering electromagnetic and climatic environments. NOTE 1 For other general requirements, such as safety, dependability, etc., see the relevant IEC 62052 or IEC 62059 standards. For accuracy requirements and other requirements specific to class indices, see the relevant IEC 62053 standards. This document applies to electricity metering equipment designed to: measure and control electrical energy on electrical networks (mains) with voltage up to 1 000 V AC, or 1 500 V DC; NOTE 2 For AC electricity meters, the voltage mentioned above is the line-to-neutral voltage derived from nominal voltages. See IEC 62052-31:2015, Table 7. NOTE 3 For meters designed for operation with LPITs, only the metering unit is considered a low voltage device. If the LPITs are rated for voltages exceeding 1 000 V AC, or 1 500 V DC, the combination of the metering unit and LPITs is not a low voltage device. have all functional elements, including add-on modules, enclosed in, or forming a single meter case with exception of indicating displays; operate with integrated displays (electromechanical or static meters); operate with detached indicating displays, or without an indicating display (static meters only); be installed in a specified matching sockets or racks; optionally, provide additional functions other than those for measurement of electrical energy. Meters designed for operation with Low Power Instrument Transformers (LPITs as defined in the IEC 61869 series) may be tested for compliance with this document and the relevant IEC 62053 series documents only if such meters and their LPITs are tested together as directly connected meters. NOTE 4 Modern electricity meters typically contain additional functions such as measurement of voltage magnitude, current magnitude, power, frequency, power factor, etc.; measurement of power quality parameters; load control functions; delivery,
Contents:
- FOREWORD
- INTRODUCTION
- Scope