Electricity metering equipment – General requirements, tests and test conditions – Part 41: Energy registration methods and requirements for multi-energy and multi-rate meters
Introduction: IEC 62052 series and IEC 62053 series define the physical, safety and metrological aspects of electricity meters. This document defines the requirements for multi-energy and multi-rate meters. This part of IEC 62052 is to be used with relevant parts of the IEC 62052, IEC 62053, IEC 62055-31, IEC 62058 and IEC 62059 series: IEC 62052-11:2020, Electricity metering equipment – General requirements, tests and test conditions – Part 11: Metering equipment IEC 62052-31:2015, Electricity metering equipment (AC) – General requirements, tests and test conditions – Part 31: Product safety requirements and tests IEC 62053-11: 2003/AMD1:2016, Electricity metering equipment (a.c.) – Particular requirements – Part 11: Electromechanical meters for active energy (classes 0,5, 1 and 2) IEC 62053-21:2020, Electricity metering equipment – Particular requirements – Part 21: Static meters for AC active energy (classes 0,5, 1 and 2) IEC 62053-22:2020, Electricity metering equipment – Particular requirements – Part 22: Static meters for AC active energy (classes 0,1 S, 0,2 S and 0,5 S) IEC 62053-23:2020, Electricity metering equipment – Particular requirements – Part 23: Static meters for reactive energy (classes 2 and 3) IEC 62053-24:2020, Electricity metering equipment – Particular requirements – Part 24: Static meters for fundamental component reactive energy (classes 0,5 S, 1 S, 1, 2 and 3) IEC 62053-41:2021, Electricity metering equipment – Particular requirements – Part 41: Static meters for
Scope: This part of IEC 62052 applies only to newly manufactured multi-energy and/or multi-rate static meters and it applies to their type tests only. NOTE 1 For other general requirements, such as electrical, mechanical, safety, marking, dependability, etc., see the relevant parts of IEC 62052 or IEC 62059. For accuracy requirements and other requirements specific to class indices, see the relevant parts of IEC 62053. This document applies to electricity metering equipment designed to: measure and control electrical energy on networks with voltage up to 1 000 V AC, or 1 500 V DC; NOTE 2 For AC electricity meters, the voltage mentioned above is the line-to-neutral voltage derived from nominal voltages. See IEC 62052-31:2015, Table 7. NOTE 3 For meters designed for operation with LPITs, only the metering unit is considered a low voltage device. If the LPITs are rated for voltages exceeding 1 000 V AC, or 1 500 V DC, the combination of the metering unit and LPITs is not a low voltage device. have all functional elements, including add-on modules, enclosed in, or forming a single meter case with exception of indicating displays; operate with integrated displays; operate with detached indicating displays, or without an indicating display; be installed in a specified matching socket or rack; optionally, provide additional functions other than those for measurement of electrical energy. Meters designed for operation with Low Power Instrument Transformers (LPITs as defined in the IEC 61869 series) may be tested for compliance with this document and the relevant IEC 62053 series documents only if such meters and their LPITs are tested together as directly connected meters. NOTE 4 Modern electricity meters typically contain additional functions such as measurement of voltage magnitude, current magnitude, power, frequency, power factor, etc.; measurement of power quality parameters; load control functions; delivery, time, test, accounting, recording functions; data communication interfaces and associated data security functions. The relevant standards for these functions may apply in addition to the requirements of this document. However, the requirements for such functions are
Contents:
- FOREWORD
- INTRODUCTION
- Scope