IEC 62129-3-2019 PDF

IEC 62129-3-2019 PDF

Calibration of wavelength / optical frequency measurement instruments-Part 3: Optical frequency meters internally referenced to a frequency comb

$100.88 $201.76 -50%
Product Code: IEC 62129-3
Stock In Stock
Edition: 1.0
Published: 05/2019
Number of Pages: 42
File Size: 1 file, 1 Byte

Available Options

Product Description

Calibration of wavelength / optical frequency measurement instruments – Part 3: Optical frequency meters internally referenced to a frequency comb

Introduction: It is essential for realizing fibre optic systems that optical channels are defined in the optical frequency domain, not the wavelength domain. One example: the anchor frequency of the ITU- T grid is 193,1 THz, and the channel spacings of the ITU-T grid are 12,5 GHz, 25 GHz, 50 GHz, and 100 GHz [1]1. ITU-T has also discussed λ-interface systems such as "black link" [2]. "Black link" includes WDM MUX/DEMUX and a transmission fibre, and provides λ-interfaces. Especially in DWDM systems (channel spacing < 100 GHz), the uncertainty in specifying optical frequency needs to be minimized. To implement future telecom systems, it is expected that optical frequency measurements will need to be extremely precise. For example, to achieve the channel spacing of 25 GHz, signal optical frequency uncertainty (Ufsig) and required measurement uncertainty (Ufmeas) need to be 2 GHz to 200 MHz (Ufsig / f = 105 to 106) and 200 MHz to 2 MHz (Ufmeas / f = 106 to 108), respectively. Unfortunately, conventional wavelength meters have measurement uncertainties of 106 to 107. The solution is to use optical frequency measurements since measurement uncertainties can be as small as 109, which satisfies the above telecom requirement (Ufmeas / f = 106 to 108). Therefore, an optical frequency measurement scheme is necessary for the calibration of future telecom systems. The frequency meter to calibrate with the procedure described in this document is the measurement equipment internally utilizing the optical

Scope: This part of IEC 62129 describes the calibration of optical frequency meters using an optical frequency comb as an internal reference. It is applicable to instruments measuring the optical frequency emitted from sources that are typical for the fibre-optic communications industry. It is assumed that the optical radiation will be coupled to the optical frequency meter by a single- mode optical fibre. This document is part of the IEC 62129 series on the calibration of wavelength/optical frequency measurement instruments. Refer to IEC 621291 [3] for the calibration of optical spectrum analyzers, and refer to IEC 62129-2 [4] for calibration of Michelson interferometer single wavelength meters.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 62129-3-2019 PDF

IEC 62129-3-2019 PDF

$100.88 $201.76