IEC 62137-1-4-2009 PDF

IEC 62137-1-4-2009 PDF

Surface mounting technology-Environmental and endurance test methods for surface mount solder joint-Part 1-4: Cyclic bending test

$50.44 $100.88 -50%
Product Code: IEC 62137-1-4
Stock In Stock
Edition: 1.0
Published: 01/2009
Number of Pages: 30
File Size: 1 file, 980 Bytes

Available Options

Product Description

Surface mounting technology – Environmental and endurance test methods for surface mount solder joint – Part 1-4: Cyclic bending test

Scope: The test method described in this part of IEC 62137 applies to surface mount components with a thin and wide basal plane, such as QFP and BGA. This test method evaluates the endurance of the solder joints between component leads and lands on a substrate by cyclic bending of substrate. This test also evaluates the effects of repeated mechanical stress, such as key pushing in cell phones, the strength of the solder joint between component terminals and lands on a substrate. In this test method, the evaluation requires first to mount the surface mount component on the substrate by reflow soldering, then cyclically bend the substrate to a certain degree of depth until fracture of the solder joints occurs. The properties of the solder joints (e.g, solder alloy, substrate, mounted device or design, etc.) are evaluated to assist in improving the strength of the solder joints. Component lead Substrate Enlarge Evaluation area Plated layers Substrate land Intermetallic compound layers Solder Substrate Component lead IEC 1174/07 Figure 1 – Image drawing on evaluation area of joint strength – 6 – 62137-1-4 © IEC:2009 2 Normative references The following referenced documents are indispensable for the application of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies. IEC 60068-1, Environmental testing – Part 1: General and guidance IEC 60194, Printed board design, manufacture and assembly – Terms and definitions IEC 61188-5 (all parts 5), Printed boards and printed board assemblies – Design and use – Part 5: Attachment (land-joint) considerations IEC 61190-1-2, Attachment materials for electronic assembly – Part 1-2: Requirements for soldering pastes for high-quality interconnects in electronics assembly IEC 61190-1-3, Attachment materials for electronic assembly – Part 1-3: Requirements for electronic grade solder alloys and fluxed and non-fluxed solid solders for electronic soldering applications IEC 61249-2-7, Materials for printed boards and other interconnecting structures – Part 2-7: Reinforced base materials clad and unclad – Epoxide woven E-glass

Contents:

  • FOREWORD
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 62137-1-4-2009 PDF

IEC 62137-1-4-2009 PDF

$50.44 $100.88