IEC 62150-4-2009 PDF

IEC 62150-4-2009 PDF

Fibre optic active components and devices-Test and measurement procedures-Part 4: Relative intensity noise using a time-domain optical detection system

$50.44 $100.88 -50%
Product Code: IEC 62150-4
Stock In Stock
Edition: 1.0
Published: 11/2009
Number of Pages: 34
File Size: 1 file, 577 Bytes

Available Options

Product Description

Fibre optic active components and devices – Test and measurement procedures – Part 4: Relative intensity noise using a time-domain optical detection system

Introduction: Laser intensity noise can be one of the limiting factors in the transmission of analogue or digital signals. It can reduce the signal-to-noise ratio and increase the bit error rate, therefore degrading system performance. Laser intensity noise can vary significantly depending on the properties of the laser and back reflections. In order to optimize communication links, it is essential to accurately characterize the laser intensity noise, compare it with the signal strength, and if necessary allow an appropriate power budget. Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. IEC shall not be held responsible for identifying any or all such patent rights. The International Electrotechnical Commission (IEC) draws attention to the fact that it is claimed that compliance with this document may involve the use of a patent concerning the FFT method for separating noise and deterministic signals given in 5.4.2. IEC takes no position concerning the evidence, validity and scope of this patent right. The holder of this patent right has assured the IEC that he/she is willing to negotiate licences under reasonable and non-discriminatory terms and conditions with applicants throughout the world. In this respect, the statement of the holder of this patent right is registered with IEC. Information may be obtained from: Agilent Technologies 1400 Fountain Grove Parkway Santa Rosa, CA 95404 Attention is drawn to the possibility

Scope: This part of IEC 62150 specifies test and measurement procedures for relative intensity noise (RIN). It applies to lasers, laser transmitters, and the transmitter portion of transceivers. This procedure examines whether the device or module satisfies the appropriate performance specification. The procedure is applicable to single longitudinal mode (SLM). An optional section of the procedure presents a controlled return loss to the device-under-test, but is only applicable to devices coupled to SMF. The method described in this standard, using a time-domain detection system, provides a single value for RIN that averages the noise over the transmission bandwidth. The measurement is made on a modulated laser capturing the RIN value under normal operating conditions. It also measures RINOMA, an alternative definition, as described in IEEE 802.3-2005. An alternative RIN measurement method uses a photoreceiver and electrical spectrum analyzer and provides RIN vs. electrical frequency. This method provides a RIN value averaged over particular electrical band determined by a filter. For a filter bandwidth and characteristic that duplicates the filtering in a transmission system, this technique provides a result that is appropriate to determine the noise for such a system. This method is based on the measurement of total intensity noise including and does attempt to subtract the effects of thermal and shot noise. Background on laser intensity noise is given in Annex A.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 62150-4-2009 PDF

IEC 62150-4-2009 PDF

$50.44 $100.88