Plugs, socket-outlets, vehicle connectors and vehicle inlets - Conductive charging of electric vehicles - Part 1: General requirements (Commented Version)
Introduction: The IEC 61851 series specifies requirements for electric vehicle (EV) conductive charging systems. The IEC 62196 series specifies the requirements for plugs, socket-outlets, vehicle connectors, vehicle inlets and cable assemblies as described in the IEC 61851 series and in IEC 62752. Some charging can be achieved by direct connection from an electric vehicle to standard socket-outlets connected to a supply network (mains or electrical grid). Some modes of charging require a dedicated supply and charging equipment incorporating control and communication circuits. IEC 62196 (all parts) covers the mechanical, electrical and performance requirements for plugs, socket-outlets, vehicle connectors and vehicle inlets for the connection between the EV supply equipment and the electric vehicle. In some situations, a cable assembly is used to directly connect an electric vehicle to a standard socket-outlet connected to a supply network (mains or electrical grid). In other situations, the electric vehicle is connected to a supply network through EV supply equipment that incorporates control and communication circuits. The IEC 62196 series covers the mechanical, electrical and performance requirements for vehicle connectors and vehicle inlets for the direct connection between an electric vehicle and a standard socket-outlet, and EV plugs, EV socket-outlets, vehicle connectors and vehicle inlets for the connection between the EV supply equipment and the electric vehicle. The IEC 62196 seri
Scope: This part of IEC 62196 is applicable to EV plugs, EV socket-outlets, vehicle connectors, vehicle inlets, herein referred to as "accessories", and to cable assemblies for electric vehicles (EV) intended for use in conductive charging systems which incorporate control means, with a rated operating voltage not exceeding 690 V AC 50 Hz to 60 Hz, at a rated current not exceeding 250 A, and 1 500 V DC at a rated current not exceeding 800 A. These accessories and cable assemblies are intended to be installed by instructed persons (IEV 195-04-02) or skilled persons (IEV 195-04-01) only. These accessories and cable assemblies are intended to be used for circuits specified in the IEC 61851 series, which operate at different voltages and frequencies, and which can include extra-low voltage circuits, such as control and communication signals circuits. These accessories and cable assemblies are intended anticipated to be used at an ambient temperature between −30 °C and +40 °C. NOTE 1 In some countries, other requirements can apply. NOTE 2 In the following country, −3540 °C applies: SE. NOTE 3 The manufacturer can enlarge the temperature range on the condition that the specified range information is provided. These accessories are intended to be connected only to cables with copper or copper-alloy conductors. The accessories covered by this document are intended for use in electric vehicle supply equipment in accordance with IEC 61851 (all parts). 1 This document does not apply to standard plugs and standard socket-outlets used for mode 1 and mode 2 according to IEC 61851-1:2017, 6.2. NOTE 4 In the following countries, mode 1 is not allowed: UK, US, CA, SG.
Contents:
- FOREWORD
- INTRODUCTION
- Scope