Plugs, socket-outlets, vehicle connectors and vehicle inlets – Conductive charging of electric vehicles – Part 6: Dimensional compatibility requirements for DC pin and contact-tube vehicle couplers intended to be used for DC EV supply equipment where protection relies on electrical separation
Introduction: With the continued development and expansion of the use of electric power into other classes of electric vehicles (EV) and hybrid electric vehicles, the introduction and commercialization of electric powered two or three wheelers (hereafter e-PTWs) are being accelerated in the global market and responding to the global concerns on CO2 reduction and energy saving. In comparison with the passenger cars, e-PTWs have a shorter range per charge and need more charging possibilities, especially public DC charging stations. This document provides general and basic requirements for a compact interface for small sized DC EV supply equipment, which could be installed in various places such as convenience stores, newspaper stands, lottery shops, etc., and could help the diffusion of e-PTWs.
Scope: This part of IEC 62196 is applicable to vehicle connectors, vehicle inlets and cable assemblies for electric vehicle (EV), intended for use in conductive charging systems which incorporate control means, with a rated operating voltage up to 120 V DC and rated current up to 100 A. These accessories are intended to be used for a DC interface of the conductive charging system according to IEC 61851-25:2020. This document applies to accessories and cable assemblies to be used in an ambient temperature of between –30 °C and +40 °C. The vehicle connector and vehicle inlets are intended to be connected only to cables with copper or copper-alloy conductors.
Contents:
- FOREWORD
- INTRODUCTION
- Scope