Railway applications – Electromagnetic compatibility – Part 4: Emission and immunity of the signalling and telecommunications apparatus
Introduction: This part of IEC 62236 has been prepared in the form of a Product Standard. It defines the immunity and emission test requirements for apparatus defined in the scope in relation to the electromagnetic disturbances likely to be experienced in the railway. In particular, the test requirements represent the essential electromagnetic immunity requirements and have been selected to ensure an adequate level of immunity for apparatus installed on the railway locations. Test requirements are specified for each port considered. Safety considerations are not covered by this document. In specific situations, where the level of disturbances may exceed the levels considered in this document, e.g. at a special location or where a hand-held transmitter is used in very close proximity to an apparatus, special mitigation measures may have to be employed.
Scope: This part of IEC 62236 applies to signalling and telecommunication apparatus that is installed inside the railway environment. Signalling and telecommunication apparatus mounted in vehicles is covered by IEC 62236-3-2:2018, signalling and telecommunication apparatus installed inside the substation and connected to substation equipment is covered by IEC 62236-5:2018. This document specifies limits for emission and immunity and provides performance criteria for signalling and telecommunications (S&T) apparatus (including power supply systems belonging to S&T) which may interfere with other apparatus inside the railway environment, or increase the total emissions for the railway environment and so risk causing Electromagnetic Interference (EMI) to apparatus outside the railway system. The requirements specified in this document apply for: vital equipment such as interlocking or command and control, apparatus inside the 3 m zone, ports of apparatus inside the 10 m zone with connection inside the 3 m zone, ports of apparatus inside the 10 m zone with cable length > 30 m. Other apparatus not covered by at least one of these given cases is in compliance with IEC 61000-6-2. If a port is intended to transmit or receive for the purpose of radio communication (intentional radiators, e.g. transponder systems), then the radiated emission requirements in this document are not intended to be applicable to the intentional transmission from a radio- transmitter as defined by the ITU. Immunity limits do not apply in the exclusion bands as defined in the corresponding EMC related standard for radio equipment. This document does not specify basic personal safety requirements for apparatus such as protection against electric shock, unsafe operation, insulation co-ordination and related dielectric tests. The requirements were developed for and are applicable to this set of apparatus when operating under normal conditions. Fault conditions of the apparatus have not been taken into account. The frequency range considered is from DC to 400 GHz. No measurements need to be performed at frequencies where no requirement is specified. For products in the scope of IEC 61000-3-2, IEC 61000-3-3
Contents:
- FOREWORD
- INTRODUCTION
- Scope