IEC 62262-2021 PDF

IEC 62262-2021 PDF

Degrees of protection provided by enclosures for electrical equipment against external mechanical impacts (IK code)

$44.14 $88.27 -50%
Product Code: IEC 62262
Stock In Stock
Edition: 1.1
Published: 09/2021
Number of Pages: 48
File Size: 1 file, 1 Byte

Available Options

Product Description

Degrees of protection provided by enclosures for electrical equipment against external mechanical impacts (IK code)

Introduction: This standard describes a system for classifying the degrees of protection provided by enclosures for electrical equipment against external mechanical impacts. Whilst this system is suitable for use with most types of electrical equipment, it should not be assumed that all the listed degrees of protection are applicable to a particular type of equipment. The manufacturer of the equipment should be consulted to determine the degrees of protection available and the parts of equipment to which the stated degree of protection applies. The adoption of this classification system, wherever possible, should promote uniformity in the methods of describing the protection provided by the enclosure and in the tests to prove the various degrees of protection. It should also reduce the number of types of test devices necessary to test a wide range of products.

Scope: This standard document refers to the classification of the degrees of protection provided by enclosures against external mechanical impacts when the rated voltage of the protected equipment is not greater than 72,5 kV. This standard is only applicable to enclosures of equipment where the specific standard establishes degrees of protection of the enclosure against mechanical impacts (expressed in this standard as “impacts”). The object of this standard document is to give a) the definitions for the degrees of protection provided by enclosures of electrical equipment as regards protection of the equipment inside the enclosure against harmful effects of mechanical impacts; b) the designations for the degrees of protection; c) the requirements for each designation; d) the tests to be performed to verify that the enclosure meets the requirements of this standard document. It will remain the responsibility of individual technical committees to decide on the extent and manner in which the classification is used in their standards and to define the "enclosure" as it applies to their equipment. However, it is recommended and to ensure that, for a given classification, the tests do not differ from those specified in this standard document. If necessary, complementary requirements may can be included in the relevant product standard. For a particular type of equipment, a product committee may can specify different requirements provided that at least the same level of safety is ensured. This standard document deals only with enclosures that are in all other respects suitable for their intended use as specified in the relevant product standard and which, from the point of view of materials and workmanship, ensure that the claimed degrees of protection are maintained under the normal conditions of use. This standard is also applicable to empty enclosures provided that the general test requirements are met and that the selected degree of protection is suitable for the type of equipment.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 62262-2021 PDF

IEC 62262-2021 PDF

$44.14 $88.27