IEC 62282-2-2012 PDF

IEC 62282-2-2012 PDF

Fuel cell technologies - Part 2: Fuel cell modules

$186.00 $371.99 -50%
Product Code: IEC 62282-2
Stock In Stock
Edition: 2.0
Published: 03/2012
Number of Pages: 86
File Size: 1 file, 616 Bytes

Available Options

Product Description

Fuel cell technologies - Part 2: Fuel cell modules

Introduction: Fuel cell modules are electrochemical devices which convert continuously supplied fuel, such as hydrogen or hydrogen rich gases, alcohols, hydrocarbons and oxidants to d.c. power, heat, water and other by-products. Fuel cell modules are sub-assemblies that are integrated into end-use products incorporating one or more fuel cell stacks and, if applicable, additional components.

Scope: This part of IEC 62282 provides the minimum requirements for safety and performance of fuel cell modules and applies to fuel cell modules with the following electrolyte chemistry: alkaline; polymer electrolyte (including direct methanol fuel cells) 1; phosphoric acid; molten carbonate; solid oxide; aqueous solution of salts. Fuel cell modules can be provided with or without an enclosure and can be operated at significant pressurization levels or close to ambient pressure. This standard deals with conditions that can yield hazards to persons and cause damage outside the fuel cell modules. Protection against damage inside the fuel cell modules is not addressed in this standard, provided it does not lead to hazards outside the module. These requirements may be superseded by other standards for equipment containing fuel cell modules as required for particular applications. This standard does not cover road vehicle applications. This standard is not intended to limit or inhibit technological advancement. An appliance employing materials or having forms of construction differing from those detailed in the requirements of this standard may be examined and tested according to the purpose of these requirements and, if found to be substantially equivalent, may be considered to comply with this standard. The fuel cell modules are components of final products. These products require evaluation to appropriate end-product safety requirements. ——————— 1 Also known as proton exchange membrane fuel cell. – 8 – 62282-2 © IEC:2012 System boundary Power inputs Electrical Thermal Useable heat Mechanical Waste heat Fuel Useable power electrical mechanical Oxidant Condensate Ventilation Inert gas Exhaust gases Water EMI noise EMD vibration vibration, wind, rain, temperature etc. Fuel cell power system Automatic Ventilation system system system Oxidant system Thermal management Fuel processing processing Fuel cell module Power conditioning system system system Water treatment system Internal power needs control Energy to elec./mech. conversion Scope IEC 331/12 Key EMD electromagnetic disturbance EMI electromagnetic interference Figure 1 – Fuel cell system components This standard cover

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope
  • 4.2.10 Live parts
  • 4.2.11 Insulating materials, dielectric strength
  • 4.2.12 Bonding
  • 4.2.13 Shock and vibration
  • 5.10 Differential pressure test
  • 5.11 Gas leakage test (repeat)
  • 5.12 Normal operation (repeat)
  • 5.13 Flammable concentration test
  • 5.14 Tests of abnormal conditions
  • 5.14.1 General
  • 5.14.2 Fuel starvation test
  • 5.14.3 Oxygen/oxidant starvation test
  • 5.14.4 Short-circuit test
  • 5.14.5 Lack of cooling/impaired cooling test
  • 5.14.6 Crossover monitoring system test
  • 5.14.7 Freeze/thaw cycle tests

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 62282-2-2012 PDF

IEC 62282-2-2012 PDF

$186.00 $371.99