Fuel cell technologies – Part 4-102: Fuel cell power systems for electrically powered industrial trucks – Performance test methods
Introduction: This part of IEC 62282-4 provides consistent and repeatable test methods for the electric, thermal and environmental performance of fuel cell power systems for industrial electric trucks electrically powered industrial trucks. The IEC 62282-4 series deals with categories such as safety, performance, and interchangeability of fuel cell power systems for propulsion other than road vehicles and auxiliary power units (APUs). This document (IEC 62282-4-102) focuses on performance test methods for fuel cell power systems for used to drive industrial electric trucks, which are being manufactured and used increasingly worldwide. This is because such applications are urgently demanded needed in the world. This part of IEC 62282-4 describes type tests and their test methods only. No routine tests are required or identified, and no performance targets are set in this document. Fuel cell systems used in industrial electric trucks electrically powered industrial trucks, such as forklift trucks, are hybrids use both batteries and fuel cells, and so operate in several different modes. Similarly, forklift trucks operate in different modes. The purpose of this document is to evaluate the fuel cell system in the various combinations of fuel cell modes and forklift truck modes. This document breaks down these different modes and provides a framework for designing and evaluating a fuel cell system for use specifically in a forklift truck. This part of IEC 62282-4 is intended to be used by either
Scope: This part of IEC 62282 specifies the performance test methods of fuel cell power systems for propulsion and auxiliary power units (APU). This document covers fuel cell power systems for propulsion other than those for road vehicles. The scope of this document is limited to electrically powered industrial trucks. Hybrid trucks that include an internal combustion engine are not included in the scope. The scope of this standard will be applicable to material-handling equipment, e.g. forklifts. This document covers the performance test methods of fuel cell power systems intended to be used for electrically powered industrial trucks as defined in ISO 5053-1, except for: rough-terrain trucks; non-stacking low-lift straddle carrier; stacking high-lift straddle carrier; rough-terrain variable-reach truck; slewing rough-terrain variable-reach truck; variable-reach container handler; pedestrian propelled trucks. This document applies to gaseous hydrogen-fuelled fuel cell power systems and direct methanol fuel cell power systems for electrically powered industrial trucks. The following fuels are considered within the scope of this document: gaseous hydrogen, and methanol. This document does not apply to reformer-equipped fuel cell power systems. This document covers the fuel cell power system as defined in 3.7 and Figure 1. This document applies to DC type fuel cell power systems, with a rated output voltage not exceeding DC 150 V for indoor and outdoor use. This document covers fuel cell power systems whose fuel source container is permanently attached to either the industrial truck or the fuel cell power system. A fuel source container of the detachable type is not permitted. Fuel cell power systems intended for operation in potentially explosive atmospheres are excluded from the scope of this document. This document does not cover the fuel storage systems using liquid hydrogen. All systems with integrated energy storage systems are covered by this document. This includes systems such as batteries for internal recharges or recharged from an external source. IEC 62282-4-102:2022 RLV © IEC 2022 – 9 – The following are not included in the scope of this document: detachable
Contents:
- FOREWORD
- INTRODUCTION
- Scope